689109
9
Zoom out
Zoom in
Previous page
1/12
Next page
21
V 11/17
HOW TO ELIMINATE CONDENSATE
Cooling
This appliance automatically vaporises condensate in the cooling and heating mode.
Ensure that when the unit is operating in cooling and heating mode, the rubber caps
closing the drainage holes on the rear of the appliance are properly positioned.
When the air conditioner operates in cooling and heating mode, there is no need for
continuous condensate drainage; only in specific weather conditions with very high air
humidity levels may water deposit inside the unit. When the internal container is full,
the display visualises message “P1” and the appliance stops functioning.
To empty the container, switch the air conditioner off and unplug it. Remove the cap
form the rear drainage hole and direct it over a normal drain.
Ensure that the tube is not twisted or bent. The tube must slope downwards. Re-close
the drainage hole with the cap and resume use of the air conditioner.
Dehumidification
WARNING!
When using the air conditioner in dehumidification mode, it is advisable to always
arrange for continuous drainage, so as to maximise dehumidification efficiency.
Connect one end of the PVC pipe provided to the rear discharge hole and place the
other end above a drain.
REMOTE CONTROL OPERATION
1. Slide to open the cover according to the direction indicated by the arrowhead.
2. Insert the batteries (CR2032/3V) into the remote control and make sure the
poles match.
3. Put back the cover.
4. Aim the remote control towards the receiver on the air-conditioner.
5. The remote control should be within 8 meters away from the receiver.
6. No obstacles between the remote control and the receiver.
7. Do not drop or throw the remote control.
8. Do not put the remote control under the strong sun rays or heating devices
and other heating sources as well.
9. Take the battery out of remote controller when you don’t use it for a long time.
10. When the operation sound can not be heard indoor unit or the transmission
symbol on the display screen does not flash, the battery need to be replaced.
11. If the rest phenomenon occurs when pressing the button of the remote control,
the electrical quantity is deficient and the battery need to be replaced.
12. Waste batteries should be disposed of properly.
Note:
* The picture is general remote controller, contains almost all the function buttons.
They may be slightly different from material abject (depend on model).
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE
2006/66/EC
Please replace batteries when flat: at the end of their useful life, batteries must not be disposed of with unsorted waste. They must
be taken to designated recycling centres or returned to a retailer providing this service. Separate disposal of batteries prevents
potential negative effects on the environment and human health due to inadequate disposal, and also allows for recovering and
recycling their constituent materials, resulting in significant savings in terms of energy and resources. The separate disposal
obligation is underlined by the crossed-out dustbin symbol appearing on the battery. Illegal disposal of the product by the user is
subject to administrative penalties as per current regulations.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Dorian at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Dorian in the language / languages: English as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info