805093
15
Zoom out
Zoom in
Previous page
1/30
Next page
46V 11/22
Clean the air lter
Use a vacuum cleaner or water to rinse the lter, and if the lter is very dirty (for
example, with greasy dirt), clean it with warm water (below 45 °C) with mild
detergent, and then put the lter in the shade to dry in the air.
Mount the air lter
Reinstall the dried lter in reverse order of removal, then
cover and lock the panel.
CHECK BEFORE USING
1. Check whether all the air inlets and outlets of the units are unblocked.
2. Check whether there is blocking in the water outlet of the drain pipe, and immediately clean it up if any.
3. Check the ground wire is reliably grounded.
4. Check whether the remote control batteries are installed, and whether the power is sufcient.
5. Check whether there is damage in the mounting bracket of the outdoor unit, and if any, please contact our local
service center.
MAINTENANCE AFTER USING
1. Cut off the power source of the air conditioner, turn off the main power switch and remove the batteries from the
remote controller.
2. Clean the lter and the unit body.
3. Remove the dust and debris from the outdoor unit.
4. Check whether there is damage in the mounting bracket of the outdoor unit, and if any, please contact our local
service center.
Do not repair the air conditioner by yourself as wrong maintenance may cause electric shock or re or explode, please
contact the authorized service center and let the professionals conduct the maintenance, and checking the following
items prior to contacting for maintenance can save your time and money.
TROUBLESHOOTING
WARNING
Phenomenon Causes Troubleshooting
The air conditioner does not work
There might be power outages.
Power plug may be loose out from the
socket.
Power switch fuse may blow.
The time for timing boot is yet to come.
Wait until power is restored.
The plug in the plug tightly.
Replace the fuse.
Wait or cancel the timer settings.
Il climatizzatore non si avvia dopo averlo
arrestato Il climatizzatore non riparte immediatamente
a causa del dispositivo di protezione
Attendere almeno 5 minuti e riprovare.
The air conditioner stops running after it starts
up for a while
May have reached the setting temperature.
May be at a defrosting state.
Shutdown Timer may be set.
It is a normal function phenomenon.
It will automatically restore and run again
after defrosting.
If you continue to use, please turn it on
again.
The wind blows out, but the cooling/heating
effect is not good
Excessive accumulation of dust on lter,
blocking at air inlet and outlet, and the
excessively small angle of the louver blades
all will affect the cooling and heating effect.
Poor cooling and heating effect caused by
doors and windows opening, and unclosed
exhaust fan.
Mode setting is incorrect, and the
temperature and wind speed settings are
not appropriate.
Please clean the lter, remove the obstacles
at the air inlet and outlet and regulate the
angle of the louver blades.
Please close the doors, windows, the
exhaust fan, etc.
Please re-select the mode, and set the
appropriate temperature and wind speed.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Charm Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Charm Plus in the language / languages: English as an attachment in your email.

The manual is 3.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Charm Plus

Argo Charm Plus User Manual - French - 31 pages

Argo Charm Plus User Manual - Italian - 31 pages

Argo Charm Plus User Manual - Spanish - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info