801725

Ardes AR4BL1 Manual

12
Zoom out
Zoom in
Previous page
1/39
Next page
12 / 39
USER INSTRUCTIONS
Product description:
(References: figure 1 at the back of the handbook)
1 – Air outlet grille
2 – Night light
3 – Control panel
4 – Base
5 – Air inlet grille
6 – Filter
7 – Main ON/OFF switch
8 – Grille hooks
9 - Remote control
Batteries
The remote control is supplied with CR2025 3V batteries; remove the protective plastic from
the battery compartment of the remote control before use.
When the battery has run out, it must be replaced with another one of the same type.
To remove the battery, refer to the diagram shown on the back of the remote control and
figure 3 at the back of the handbook.
Description of controls:
(References: figures 1 and 2 at the back of the handbook)
To turn the device on, the plug must be inserted in the power socket and the switch (7) to
turned to “I”.
“ON/OFF” button (A)
When the device is switched off, press this button to turn it on.
The device switches on in summer ventilation mode (indicator b3 on) and the display (h)
shows the room temperature.
When the device is switched on, press this button to turn it off.
“MODE” switch (B)
Press this button to change the operating mode; ventilation (indicator b3), minimum heating
(indicator b2) and maximum heating (indicators b1+ b2).
“LIGHT” button (C)
Press this button to change the colour of the night light (2): off, light blue, blue, purple, red.
The night light can be turned on even when the device is switched off, with the switch (7) on
I.
“TIMER” button (D)
Press the TIMER (D) button when the device is working to program automatic switch-off at
an interval of between 1 to 12 hours from when it is programmed. Every time the button is
pressed, the interval increases by one hour.
A few seconds after selecting the timer, the display will show the room temperature again.
When the timer function is activated, the indicator (d) lights up on the control panel. To
disable the timer function, press the timer button repeatedly until the display shows “0 0”.
“SWING” button (E)
Press this button to activate or deactivate the automatic swing function of the device. When
the swing function is active, the corresponding indicator (e) lights up.
TEMP button (G) (F)
Press one of these buttons to set the desired room temperature (automatic function); the set
temperature will flash on the display (h).
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ardes AR4BL1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ardes AR4BL1 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0.9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info