765013
89
Zoom out
Zoom in
Previous page
1/124
Next page
If the dashboard still reects Sanitizing contact your Arctic Spas Dealer who will request a Master Tech-
nician to log onto your spa to determine the possible cause, such as depleted Spa Boy Output Elec-
trode, Spa Boy Sensor issue or corroded Spa Boy Output Electrode electrical connections.
Question 6 If the Spa Boy System is not working, can I add Arctic Pure BOOST or other sanitizer to the
spas water? Yes you can add Arctic Pure BOOST if needed. Arctic Pure BOOST or other chlorine sanitizer
shouldn’t need to be added regularly to keep up with regular bather load. Adding Arctic Pure BOOST or other
chlorine sanitizers will raise sanitizer levels above the Spa Boy Systems maintained chlorine/ORP optimum
range (545mV-550mV) causing the Spa Boy System to shut down until the chlorine/ORP reading is below the
optimum range, 545mV/ORP.
Adding BOOST can temporarily “poison” the SpaBoy sensor for 24-48 hours. Do not trust the ORP reading
until water has stabilized.
Question 7 Is it permitted to add Arctic Pure Refresh directly to the spas water? If your spa is not
equipped with Arctic Spa Ozone such as Peak 1 or Peak 2 it is a good idea to add 1 cap full per week.
Question 8 How do I help prevent impedance increase at the Spa Boy Electrode? Maintain the pH level
within the target range 7.2 pH – 7.6 pH. As salt systems naturally drive pH levels upwards, it is most critical to
the performance/life of the salt system to maintain the pH within the target range. High pH reduces the e󰀨ec-
tiveness of chlorine.
• pH level of 7 makes chlorine 70% e󰀨ective (30% loss of e󰀨ectiveness).
• pH level of 8 makes chlorine 21% e󰀨ective (79% loss of e󰀨ectiveness).
Therefore, high pH causes your Spa Boy system to produce more chlorine unnecessarily thus increasing pH
even higher and reducing the e󰀨ectiveness of chlorine even further. Strive to achieve a Low pH level 7.2. pH
must not exceed 7.6.
Question 9 Why is my water bright yellow, or bright green, or a rusty color suddenly? This can happen
if the pH gets too high. Maintain the pH level within the target range 7.2 pH – 7.8 ph. Lower the pH using ‘Salt
Water Balance’. If the color of the water does not normalize you may need to replace the water. If pH readings
are 8.2ppm or above, a pH error will be displayed on the Top Side Controller every ve seconds until the pH is
corrected.
* Keep an eye on the pH and adjust it weekly to avoid this problem in the future.
Understanding Spa Boy®
Owners Manual - Spa Boy®
8989
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arctic Spas Totem at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arctic Spas Totem in the language / languages: English as an attachment in your email.

The manual is 5,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info