765013
78
Zoom out
Zoom in
Previous page
1/124
Next page
1.8 Denitions of Terms
TERM DEFINITION
Sanitizer Chemical used to kill bacteria.
Generic names: Chlorine, Bromine and Biguanide.
Arctic Pure, Boost
Adding Arctic Pure BOOST should be avoided unless the ORP level is very
low.
Also Refer Section 1.15 Caring for your Spa Boy System, Question 3 If
the Spa Boy System is not working, what should I do if I need to add Arctic
Pure BOOST or other sanitizer to the spas water?
Note; resetting the spas breaker could speed up sensor recovery.
Refresh Oxidiser that is pH Neautral
An oxidizer that “burns o󰀨” the organic wastes which cause cloudiness and
algae. It is a generic term for a chemical used to oxidize organic wastes.
If your spa is equiped with an Arctic Spas OZONE System such as Peak
1 or Peak 2 in most cases there should be a reduced need to add Arctic
Pure, Refresh to your spas water. This is dependent on bather load and
OZONE run time. But weekly maintenance is required.
Parts Per Million (ppm) ppm: parts per million, a standard measure of chemical or mineral concen-
tration.
Organic waste Debris such as microorganisms, perspiration, urine, etc. which needs to be
burned up or “oxidized” regularly to prevent haze, algae, chloramines, etc.
Shock An oxidizer that “burns o󰀨” the organic wastes which cause cloudiness and
algae. It is a generic term for a chemical used to oxidize organic wastes.
Arctic Pure, Boost.
Warning Adding a Chlorine agent such as Boost to the spas water should
be avioded as this will a󰀨ect the Spa Boy Sensor Probe which will cause
inacurate ORP and pH readings to be sent to My Arctic Spa and registered
with My Arctic Spa. If chlorine is added to the spas water it will take at least
three days for the Spa Boy Sensor Probe to clense itself and start sending
accurate readings to My Arctic Spa.
Also Refer Section 1.15 Caring for your Spa Boy System, Question 3 If the
Spa Boy System is not working, what should I do if I need to add Arctic Pure
BOOST or other sanitizer to the spas water?
Note; resetting the spas breaker could speed up sensor recovery.
Salt Water Balance Arctic pure product specially formulated by Arctic Spas to lower pH without
causing any damage to the Spa Boy Output Electrode.
Drop Test Kit Test kit for testing spa water sample using additives instead of test
stips. This type of test method is more e󰀨ective at measuring the
0.5ppm residual amount of chlorine generated through Spa Boy.
0.5ppm Chlorine reading = approximately 550mV
Understanding Spa Boy®
Owners Manual - Spa Boy®
7878
78


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arctic Spas Totem at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arctic Spas Totem in the language / languages: English as an attachment in your email.

The manual is 5,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info