765004
112
Zoom out
Zoom in
Previous page
1/124
Next page
Onzen Questions
Question 1: How do I know if the Onzen system is working?
Conduct a “Sanitizer Production test” (Also known as a Smoke test).
This procedure activates the Onzen System while de-activating the ltration pump so you can see the
mist of gas bubbles produced by the Onzen System.
Question 2: What should I do if it fails the “Sanitizer Production test”?
First, conrm you have the correct concentration of salt in the water “using sodium chloride test strips”.
Then, start maintaining your water manually using “Boost” granular chlorine to sanitize and Adjust Up /
Arctic Pure Salt Water Balance to balance pH. Continue to do this daily until the system is repaired by an
authorized service technician.
* Keep enjoying your hot tub!
Question 3: What should I do if the chlorine levels are too high?
Turn the Onzen Output down (decrease “On” settings).
Unless you added granular chlorine or shock to the water high chlorine levels mean the system is staying
on too long for your circumstances. It may take a day or two for levels to normalize, or you can speed this
process up by using a chlorine neutralizer, such as “X-it”.
Question 4: What should I do if the pH keeps increasing?
Conrm that your Total Alkalinity is at the recommended level and reduce it manually with Arctic Pure Salt
Water Balance. This is normal; all spa salt systems cause pH to increase.
Question 5: Will the salted water damage my lawn?
This is very unlikely.
The recommended concentration of salt is used is approximately 10% of the concentration of sea water.
Question 6: Why is my water bright yellow, or bright green, or a rusty colour suddenly?
This can happen if the pH gets too high.
Lower the pH using Arctic Pure Salt Water Balance. High pH is a sign that the Onzen Output may be
turned up too high, so you may need to adjust the Onzen Output After balancing the pH and adjusting the
Onzen Output wait about 48 hours. If the colour of the water does not normalize you may need to replace
the water.
* Keep an eye on the pH and adjust it weekly to avoid this problem in the future.
Question 7: What is the typical amount of maintenance I need to do with Onzen?
1. Change the water twice a year.
2. Change the lter 4 times a year.
3. Check the Total Alkalinity weekly to make sure it is in the target range (Under 100).
4. Adjust the pH once a week. Salt systems naturally drive pH levels to increase, strive to achieve a Low
pH level 7.2
must not exceed 7.6.
5. Check Calcium level monthly to ensure it is in the target range. Salt systems perform best with Low
Calcium levels;
strive for a target range between 50 - 150 ppm.
6. Adjust the Onzen Output “On” if hot tub use changes signicantly.
7. Adjust the chlorine levels using “Boost” granular chlorine, after heavy use or if the Onzen Output is too
low. Refer: Onzen Maintenance Schedule for further details.
1.12 Onzen Frequently Asked Questions
112112
Understanding Onzen™
Owners Manual - Onzen™
112


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arctic Spas Klondiker at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arctic Spas Klondiker in the language / languages: English as an attachment in your email.

The manual is 5,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info