371605
10
Zoom out
Zoom in
Previous page
1/30
Next page
1 0
listening in a second room
Solo Movie 5.1 provides two independent volume controls, offering you the
possibility of listening to the same output in two different rooms. To do this, you need
the following:
< a power amplifier (such as the Arcam P90) and speakers
< suitable interconnect cables
< a remote control receiver (optional), available from your Arcam dealer
< a second remote control (optional), available from your Arcam dealer.
Make the connections as follows:
1. Ensure that all equipment is switched off and disconnected from the mains
supply.
2. Connect the
ZONE 2/REC OUT outputs of Solo Movie 5.1 to the audio inputs
of the power amplifier using interconnect cables.
3. Connect the speakers to the speaker terminals of the power amplifier.
4. Plug the remote receiver from the second room into the connector
labelled REMOTE IN ZONE 2 on the rear of Solo Movie 5.1.
5. Reconnect the equipment to the mains supply and switch
on. You should be able to hear the output of Solo
Movie 5.1 through the remote power amplifier,
and control the volume using the remote
control.
Zone 2 volume control
Note that the second room is always muted
when Solo Movie 5.1 is switched on – it must be
unmuted ‘explicitly’ when required. This is to avoid
unexpected output in the remote location.
The Zone 2 volume can be controlled from the
main room by using the front panel controls or the
remote control.
Front panel control:
1. Press and hold the INFO button to turn the ‘Zone 2
Volume’ display on.
2. Unmute or change the previous volume setting by pressing the
VOLUME+ or –VOLUME buttons.
Remote control:
1. Press the AMP button to ensure that the CR100 is in Amplifier modes.
2. Press
SHIFT +
4
to turn the ‘Zone 2 Volume’ display on.
3. Unmute or change the previous volume setting by pressing the
+ or
buttons.
The ‘Zone 2 Volume’ display defaults to the previous display after about five seconds.
viewing in a second room
If your set up is suitable for simultaneous video output (see ‘Using two video
connections simultaneously’, page 8), you can use the Composite video output for
Zone 2.
Remember that Solo Movie 5.1 does not carry out video conversion, so for
Composite video to be available for Zone 2, it must be input as Composite video.
If you have a SCART-equipped unit, Composite video is included in the SCART
connection. If you have a Component (YUV) video unit, you will need to connect the
Composite signal using a Phono–Phono (RCA) cable rated at 75Ω.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam solo movie 5 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam solo movie 5 1 in the language / languages: English as an attachment in your email.

The manual is 2,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Arcam solo movie 5 1

Arcam solo movie 5 1 User Manual - German - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info