160363
7
Zoom out
Zoom in
Previous page
1/18
Next page
7
solo
mini
English
positioning
Positioning the unit
< Place Solo Mini on a level, rm surface, avoiding
direct sunlight and sources of heat or damp.
< Do not place Solo Mini on top of a power
amplier or other source of heat.
< Do not place Solo Mini in an enclosed space such
as a bookcase or closed cabinet unless there
is good provision for ventilation. Solo Mini is
designed to run warm during normal operation.
< Do not place any other component or item on
top of Solo Mini as this may obstruct airow
around and through the unit, causing Solo Mini to
overheat.
< Do not obstruct the vents in the top, bottom, or
sides of Solo Mini.
< Make sure the remote-control receiver on the
left-hand side of the display is unobstructed,
otherwise the remote control will not work
reliably.
Power
Solo Mini is supplied with a moulded mains plug already
tted to the lead. Check that the plug supplied ts your
supply – should you require a new mains lead, please
contact your Arcam dealer.
Push the IEC plug end of the power cable into the
socket on the back of Solo Mini, making sure that it is
pushed in rmly. Plug the other end of the cable into
your mains socket and, if necessary, switch the socket
on.
Solo Mini is tted with a power switch on the rear
panel, below the power inlet: make sure that this is
switched on.
Solo Mini is tted with a transformer designed to
accept the mains voltage in the region that the product
was shipped to. If your mains supply voltage does not
match the specication printed on the rear panel, or
you wish to take the unit to a region with a different
mains voltage, or the mains plug is incorrect, please
contact your Arcam dealer.
Thermal protection
Make sure that the unit receives adequate ventilation at
all times (see ‘Positioning the unit’).
If Solo Mini gets too hot, an ‘Over Temperature’
warning is shown on the front panel and the unit shuts
down to protect itself. You can restart Solo Mini after it
has cooled for 15 minutes without power.
Interconnect cables
We recommend the use of high-quality screened cables
that are designed for the particular application. All
cables should be kept as short as is practically poss ble.
To avoid unwanted noise in the audio signals, make sure
that the mains power-supply cabling is kept as far away
as possible from your audio cables.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam solo mini at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam solo mini in the language / languages: English as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Arcam solo mini

Arcam solo mini User Manual - German, Dutch, French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info