65473

Arcam DV79 Manual

6
Zoom out
Zoom in
Previous page
1/42
Next page
DV79
E-6
English
DV79
E-7
Positioning the unit
Place the DV79 on a level,  rm surface and ensure that there is adequate ventilation for the unit.
Connecting the video output
To view the pictures from the DVD player you need to connect one of its video outputs to your display
device (TV, monitor, projector, etc.).
The DV79 has six video output options:
n
Component video
n
Composite video
n
RGB
n
Progressive scan component 525P (480P) and 625P (576P) video
n
S-video
n
HDMI digital video
You only need to use one type of video from the list; choose a type that your display device supports. If
your display device does not support any of the above connection types then you will be unable to use it
with the DV79; in this case, please contact your dealer for futher assistance.
Note that you may connect equipment such as AV receivers in the signal path between the DVD player
and the display device, so long that the connected equipment also supports the type of video signal you
intend to use. For instructions on how to connect AV equipment, consult the manual for that equipment.
NOTE: The DVD player supports either component video or RGB video at any one time, but not both.
This is speci ed in the set-up menu (see page 12). If you use either of these outputs with an incorrect
menu setting, no damage will occur but the picture will be coloured in a strange way. Similar effects
result from cross-connection of the three signals.
If you use component video outputs, you must ensure that the SCART socket is not used. Similarly, if
the SCART socket is used, disconnect the component video leads.
Composite video
If your display device offers only a composite input (sometimes labelled CVBS or just ‘video’), connect
this to the COMPOSITE video output of the DVD player using a 75Ω phono cable suitable for video use.
Note that a composite video connection gives the lowest quality output; if your display device supports
other video connection types, we advise that those are used instead.
S-Video
The S-Video output (also known as S-VHS or Y/C) is commonly supported by display devices worldwide.
Connect the S-VIDEO output of the DVD player to the S-Video input of the display device using an
appropriate cable.
Component video
Use three 75Ω phono cables to connect the Component Y, Pb, Pr
outputs of the DVD player to the Y, Pb, Pr inputs of the display
device. Ensure that the cables are suitable for video use and that
they are approximately the same length.
Some component video interfaces are labelled differently to the
DV79; see the table if the component inputs of your display device
are not labelled ‘Y, Pb, Pr’.
RGB/SCART output
RGB output is available on both the SCART and Component/RGB sockets and offers picture quality equal
to component video.
Use appropriate cables to connect either the SCART connector or RGB phonos to your display device.
Note that if you are using RGB output via phono connectors, you will also need to use the COMPOSITE
signal as a synchronisation signal.
Installation
DV79 alternative alternative alternative
Y Y Y Y
Pb Cb (B–Y) U
Pr Cr (R–Y) V
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam DV79 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam DV79 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info