578786
4
Zoom out
Zoom in
Previous page
1/12
Next page
T61
4
Installation
T61 rear panel
1
Socket for IEC power inlet line
2
Voltage selector switch
3
Remote control input
4
Power On/Standby trigger in
5
AM step switch
Positioning the unit
Always place the tuner on a level, rm surface.
Setting up the tuner
AM step switch
5
The AM tuning step size needs to be set according to your
location. This is done using the switch on the rear panel: set
it to 10kHz if you are in North America, or 9kHz anywhere
else. This switch also ensures correct reproduction of FM
broadcasts for your location.
AM aerial
An AM aerial is required to receive AM/Medium Wave radio
signals.
An external AM loop aerial is supplied as an accessory. This
should be attached to the AM Antenna inputs with one end
connected to AM
9
and the other to Ground
8
. It does not
matter which way round this aerial is tted. Rotate the aerial to
discover which position gives the best reception.
In areas of weak reception or when the receiver is used inside
a steel framed building (such as an apartment building) you
can use a wire between 3 and 5 metres long to strengthen
reception. Mount this high up outside the building, if possible,
and connect one end of this wire to the AM antenna input
9
as well as the loop aerial supplied. DO NOT DISCONNECT THE
LOOP AERIAL.
123 654
L
R
AUDIO
OUTPUTS
1
2
AERIALS
FM 75 GND AM
POWER INLET
120V 230V
789
IR IN
12V
TRIGGER
IN
AM STEP
6
Audio output phono sockets, two
pairs
7
FM coaxial plug
8
Ground socket (for AM loop aerial)
9
AM socket (for AM loop aerial)
FM aerial
An FM aerial is required to receive VHF radio signals. An
external FM ribbon aerial is supplied as an accessory.
For optimal FM radio reception a roof or loft mounted aerial is
advised. For your own safety it is recommended that a roof top
aerial is tted by an experienced contractor. Your Arcam dealer
should be able to put you in contact with an aerial installer.
A contractor will be able to tune your aerial to the nearest
FM transmitter. In an apartment building an aerial system may
already be installed. If this is the case you should have sockets in
your home marked FM or VHF (do not use those marked TV).
The T shaped wire aerial (dipole design) supplied should give
reasonably good reception. Mount this aerial as high up as
possible on a wall with the elements positioned horizontally. Try
each usable wall of the room to see which gives best reception.
Use tacks or adhesive tape to secure the aerial in a T shape.
The tacks should not come into contact with the internal wire
of the aerial.
Whether you decide to get an aerial professionally installed or
opt to use the supplied aerial it should be connected to the FM
Antenna input
7
on the rear of the unit.
For use in North America, use an F-type antenna connector; for
Europe and other areas, use a female Belling Lee-type coaxial
connector.
T61 issue2.id 05/30/02, 7:43 PM4
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam DiVA T61 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam DiVA T61 in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info