578781

Arcam DiVA DT91 DAB Manual

11
Zoom out
Zoom in
Previous page
1/15
Next page
DT91
E-10
English
DT91
E-11
Appendix: Serial programming interface
Introduction
This section of the document describes the remote control protocol for controlling the DT91 via the
RS232 interface.
Conventions
n The remote controller is referred to as the ‘RC’.
n All values in this section are hexadecimal values, unless otherwise specied.
Data transfer format
n Transfer rate: 19,200bps.
n 1 start bit, 8 data bits, 1 stop bit, no parity, no ow control.
Command and response formats
Communication between the RC and the DT91 takes the form of sequences of bytes, with all commands
and responses having the same basic format. Communication between the two is full duplex. The DT91
shall always respond to a received command.
Each transmission by the RC shall be at least ve bytes long in the following format:
<STR> <CC> <DL> <Data> <ETR>
n STR (Start transmission): 0x21
n CC (Command code): the code for the command
n DL (Data length): the number of data items following this item, excluding the ETR
n Data: the parameters for the command
n ETR (End transmission): 0xD
Each response by the DT91 shall be at least six bytes long in the following format:
<STR> <RC> <AC> <DL> <Data> <ETR>
n STR (Start transmission): 0x21
n RC (Reply code): = command code
n AC (Answer code): answer code (see below)
n DL (Data length): the number of data items following this item, excluding the ETR
n Data: the information associated with this response
n ETR (End transmission): 0xD
Note that the DT91 shall transmit messages whenever its status changes.
State changes as a result of other inputs
It is possible that the state of the DT91 may be changed as a result of user input via the front panel
buttons or via the IR remote control. Changes resulting from these inputs shall be relayed to the RC
(using the appropriate message type) as they occur.
For example, if the user changed the front panel display brightness using the DISP button on the remote
control, a display message (dened below) would be sent to the RC. A similar action would be taken for
all other state changes.
Answer codes
The following answer codes are dened:
n Command OK 0x1: The command has been accepted and processed completely.
n Command Failed 0x0: The command has failed for some reason.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam DiVA DT91 DAB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam DiVA DT91 DAB in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info