Arada Farringdon 12 2
PLEASE NOTE— Arada has a policy of continuous product development and therefore we
reserve the right to amend the specification without prior notice.
Due to printing cycles, items or options may be described before they are generally available
or after they have ceased, so please check with your retailer or dealer.
Congratulations on your choice of an Arada Stove.
Read all instructions carefully before installing your wood burning stove.
If you are in any doubt about the instruction
to install your appliance correctly, we suggest to call a professional
master installer. A wrong installation may result with a fire, burns and possible death.
Keep these instructions.
This appliance must be connect to
· A HT type factory-built chimney approved UL103 or ULC 629 with a 6 inches dia. (15.24 cm)
· A code-approved masonry chimney with a flue liner with a 6 inches diameter (15.24cm)
N.B: Be warned that local codes and rules can have more specific requirements than those
detailed in this manual.
You should consult a master installer, fire officials or local building office about restriction and
installation inspection in your area and to determine if you need to obtain a permit
Prior to installation.
Install and operate this stove only in accordance with these instruction
Applicable standards: UL 1482-22, CAN/ULC S627-22
We recommend our wood
burning stoves be fitted by
an installation engineer certified in the US by
The National Fireplace Institute (NFI)
And in Canada, by the Wood Energy
Technology Transfer (WETT)
This manual describes the installation and operation of the Arada, Farringdon 12 wood heater.
This heater meets the 2020 U.S. Environmental Protection Agency’s cored wood emission limits for
wood heaters sold after May 15, 2020.
This wood heater was tested to EPA Method 28R using Cored fuel with an emissions value of
1.79g/hr.
Under specific test conditions this heater has been shown to deliver heat at rates ranging from
12,600 to 40,400 Btu/hr 3.7 - 11.8kw/hr
This wood heater has a manufacturer-set minimum low burn rate that must not be altered. It is
against federal regulations to alter this setting or otherwise operate this wood heater in a manner
inconsistent with operating instructions in this manual.
This wood heater, needs periodic inspection and servicing for to ensure proper operation.