Page 30 BK740
Ecoburn (S3) Stove User Guide
14. Additional Information
14.1 Reduced Distances To Combustibles
For installations, where the optional heat shield has been fitted to the appliance, reduced
distances to combustible materials for can be observed, as stated in the table on page 28
(Figures highlighted by *).
These reduced distances can be taken into account during installation, however, the
minimum distances were ONLY achieved when using the optional rear heat shield and
single walled flue pipe fitted to the appliance.
14.2 Twin walled flue—Reduced Distances
For twin walled flue installations, reduced distances to combustible materials can be
observed, as stated in the table on page 28 (Figures highlighted by **). This information
can also be found on the data label attached to the stove.
These reduced distances can be taken into account during installation, however, the
minimum distances were ONLY achieved when using Arada specified twin wall starter
section (Schiedel 5” (149644) & 6” (149645)) and when also the optional rear heat shield
has been fitted to the appliance.
14.3 Solid Fuel Burning Performance
The solid fuel burning data figures (footnotes ‘1’), as stated in the specification table on
page 29, were achieved when burning Maxibrite briquettes, using the optional solid fuel
burning kit, fitted to the stove.
Burning solid fuel on the wood grate will note achieve the stated figures and will shorten
the life expectancy of the grate and firebox liner components.
15. Optional Accessories
Optional accessories can be purchased from your supplying dealer or from the Arada web
site, for the Ecoburn S3 range, the following accessories are available :
• Solid fuel kit (AFS 4547)
• Rear Heat Shield (AFS 4545)
• Direct Air Connector (AFS 4543)
• Log Store (LOG-xx) - ‘xx’ denotes size
• Stand (STAND-xx) - ‘xx’ denotes size
