813451

Arada Defra Manual

14
Zoom out
Zoom in
Previous page
1/32
Next page
DEFRA Stove Installation and User Guide
If the chimney is old (i.e: built of brick or stone without a liner) or being
opened up for reuse additional checks and smoke testing as described in
Appendix E of the Approved Document J 2010 Edition should also be carried
out to ensure the ue and chimney are in good operating condition.
Check the existing ue is in good condition with suitable access for
collection and removal of debris.
It is also important that suitable ue pipe (recommended at least
600mm in length) complying with the Building Regulations is used to
connect the stove to the ue in the chimney. Suitable access should be
provided into the ue for regular inspection and sweeping of the ue ways.
The installer should comply with Building Regulations requirements in
respect of providing a Notice Plate giving details on the chimney, ue lining,
hearth and replace installation.
Chimneys should be as straight as possible. Horizontal runs should be
avoided except where the rear outlet of the appliance is used, in which case
the horizontal section should not exceed 150mm in length. If necessary
a combination of 45 ◦and 90 ◦bends can be used as long as the sum of
their angles is not greater then 180 ◦in total. i.e four 45 ◦bends, or two
45 ◦and a 90 ◦bend.
If the stove appears to be working hard but produces very little output
to the room it is likely that excess draw is present in the chimney, and that
heat is being sucked out of the appliance and up the chimney. If this is
the case we recommend the tting of a draught stabiliser in preference to
a ue damper, in the interest of safety and eciency.
4 Commissioning the stove
Before handing over the installation to the customer it is a requirement
under Document J (of the Building Regulations for England and Wales) that
the appliance is lit and the functioning of the chimney system is checked
for satisfactory operation.
•Be sure that the chimney is operating and all smoke and fumes are
vented to the atmosphere through the chimney terminal.
BK575 Rev02 10
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arada Defra at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arada Defra in the language / languages: English as an attachment in your email.

The manual is 6.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info