729424
6
Zoom out
Zoom in
Previous page
1/35
Next page
5
8. REL
/ (PMIN/MAX) switch A. In voltage and current modes, pressing REL performs maximum and
minimum PEAK hold function. Pressing REL toggles between PMIN
and PMAX measured values and the PMIN or PMAX annunciators are
displayed. To calibrate this function press and hold REL until the CAL
annunciator is displayed, then short the test leads until the display reads
zero. Press and hold the REL switch to exit this function.
B. In all other modes pressing the REL switch precuts comparison
between two measured values. When taking the first measurement press
the REL switch to store the reading, the REL annunciator will be dis-
played and the reading is zeroed. When taking the second measurement
the display will show the difference between measurement 2 and measure-
ment 1 (will be negative if measurement 1 is large than measurement 2 ).
Pressing the REL switch again causes the display to show measure-
ment 2, and the REL annunciator will flash. To exit this mode press and
hold the REL switch for 2 seconds.
9. MIN/MAX switch This switch is used to display MAX and MIN values of measurement, press 2 seconds to
quit. In this mode, when MAXMIN is blinking the reading is of measuring signal.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Appa 99 II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Appa 99 II in the language / languages: English as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info