471451
35
Zoom out
Zoom in
Previous page
1/46
Next page
33-EN
ALPINE DHA-S690 68-09359Z17-A (EN)
Playback does not start.
Disc is loaded upside-down.
-
Check the disc and load it with the labeled side facing upward.
Disc is dirty.
- Clean the disc.
•A disc not able to playback with this unit is loaded.
- Check if the disc is able to be played back.
•Parental lock is set.
- Cancel the parental lock or change the rating level.
Setup menu is displayed.
- Press and hold SETUP for at least 2 seconds to turn the
menu off.
Picture is unclear or noisy.
Disc is being fast-forwarded or fast-reversed.
-The picture may be unclear, but this is normal.
•Vehicle’s battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
Monitor’s fluorescent tube is worn out.
-Replace the monitor’s fluorescent tube.
Unable to turn the power off by switching sources on
the head unit. (Only when an Ai-NET compatible (AV)
head unit is connected.)
•The switched (ignition) power lead for this unit is connected.
- Do not connect the switched (ignition) power lead for this
unit when an Ai-NET compatible (AV) head unit is
connected.
Playing back a DRM protected DivX
®
File
Some operations cannot be performed while displaying the following
message.
“Authorization Error”
If a non-approved DRM protected DivX
®
file that does not
comply with the registration code of the unit is played back,
“Authorization Error” is displayed for 2 seconds, meaning the
file cannot be played back. After the message has been
displayed, the beginning of the next file will automatically be
played back.
“Rental Expired”
•There is a rental file in the DivX
®
that is set to audio/visual
times. If audio/visual time is counted as 0, “Rental Expired” is
displayed for 2 seconds, indicating that the file cannot be
played back. After the message has been displayed, the
beginning of the next file will automatically be played back.
“Rental countdown OK?”
•While playing back a rental file, if B.SKIP or ENTER in the
file selection menu is selected, “Rental countdown OK?” is
displayed, and the rental file playback is interrupted (audio/
visual times are reduced by 1). The file has paused (PAUSE) at
the time. To interrupt the playback, select [YES], or select
[NO] to not be interrupted.
“This rental has (remaining times) views left.
View DivX
®
VOD Rental?”
If audio/visual times still remain, the remaining number of
playback times is displayed. To play back, select [YES]. If the
next file is to be played back, select [NO].
In Case of Difficulty
If you encounter a problem, please turn the power off, then on again.
If the unit is still not functioning normally, please review the items in
the following checklist. This guide will help you isolate the problem
if the unit is at fault. Otherwise, make sure the rest of your system is
properly connected or consult your authorized Alpine dealer.
No function or display.
•Vehicle’s ignition is off.
- If connected following the instructions, the unit will not
operate with the vehicle’s ignition off.
Improper power lead connections.
- Check power lead connections.
Blown fuse.
- Replace the fuse on the battery lead of the unit with the
proper value.
Unable to fast forward or reverse the disc.
The disc has been damaged.
- Eject the disc and discard it; using a damaged disc in your
unit can cause damage to the mechanism.
Disc playback sound skips due to vibration.
Improper mounting of the unit.
- Securely re-mount the unit.
Disc is very dirty.
- Clean the disc.
Disc has scratches.
- Change the disc.
•The pick-up lens is dirty.
- Do not use a commercial available lens cleaner disc.
Consult your nearest ALPINE dealer.
Disc playback sound skips without vibration.
Dirty or scratched disc.
- Clean the disc; damaged disc should be replaced.
CD-R/CD-RW playback not possible.
Close session (finalization) has not been performed.
-Perform finalization and attempt playback again.
Error displays
Mechanical error
-Press c. After the error indication disappears, insert the
magazine again. If the above-mentioned solution does not
solve the problem, consult your nearest ALPINE dealer.
MP3/WMA/AAC is not played back.
•Writing error occurred. The CD format is not compatible.
- Make sure the CD has been written in a supported format.
Refer to “About MP3/WMA/AAC” on pages 17-18, then
rewrite in the format supported by this device.
Unit does not operate.
Monitor’s power is not turned on.
-Turn on the monitor’s power.
Condensation.
-Wait a while (about 1 hour) for the condensation to dry.
No picture is produced.
Monitor’s mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
Monitor’s parking brake cord is not connected.
- Connect the monitor’s parking brake cord and set the parking
brake. (For details, refer to the monitor’s instructions.)
Monitor’s parking brake is not set.
- Connect the monitor’s parking brake cord and set the parking
brake. (For details, refer to the monitor’s instructions.)
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Apine DHA-S690 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Apine DHA-S690 in the language / languages: English as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info