807556
9
Zoom out
Zoom in
Previous page
1/32
Next page
9
4. SAFETY PRECAUTIONS
Keep children away and do not allow
children to operate this device!
Only use this product as intended!
Do not manipulate or disassemble the
device!
For your own safety, only use accessories
and spare parts that are stated in these
instructions or that are recommended by the
manufacturer!
The warning triangle labels all instructions
important to safety. Always follow the-
se otherwise you could injure yourself or
damage the device.
Do not smoke and do not ignite naked
ames when working on the battery. There
is a risk of explosion.
Only connect the device to a power socket
installed according to regulations. The vol-
tage must correspond to the specication on
the type plate of the device.
Do not trap the power cable and protect it
from sharp edges, damp, heat or oil. The
power cable of the unit cannot be replaced.
In the event that the cable is damaged, the
unit must be disposed of.
Do not operate the device or immediately
pull the plug if it is damaged or you suspect
it may be defective. In this case, contact our
technicians.
Pull the plug when the device is not in use.
Keep packaging materials, especially plastic
and plastic bags, away from children. Risk of
suocation.
Remove all plastic from the device before
use.
Place the mains cable in such a manner that
it does not impede and that it cannot be
unplugged accidentally.
Disconnect the battery charger from the
power supply after the charging process.
Keep the charger in a place that cannot
be accessed by children or unauthorised
persons.
Never operate the device in the vicinity of
ammable materials or in an environment
prone to explosion.
Always wear suitable working
lothes, protective gloves and goggles.
Battery acid is corrosive! Immediately and
thoroughly wash o any splashed acid and
consult a doctor, if necessary. If battery acid
gets into the eyes, immediately rinse under
running water for at least 10 minutes and
consult a doctor.
Do not cover the charger, this may lead to
overheating and result in damages. Never set
the charger up for operation on a surface that
is insulating (e.g. polystyrene). There is a risk
of heat built up!
If you wish to charge a vehicle battery in the
installed state, rst park the vehicle safely,
put on the parking break and switch o the
ignition. Cut the battery o from the on-
board network of your vehicle. To do this,
consult the manual for your vehicle, or ask
your specialist workshop.
This charger enables you to charge a battery
without needing to disconnect it from the
on-board network. If you wish to make use
of this option, make sure that your vehicle
will not be damaged by this process. For this
purpose, read the manual of your vehicle or
ask your specialist workshop.
To remove the battery charger, rst pull
the plug out of the socket and observe the
sequence for disconnection. This prevents
sparks from forming. Since charging gene-
rates a detonating gas, this is particularly
important for the sake of your safety.
Only hold the power cable at the power plug
when disconnecting from the power socket.
Never expose the charger to the vicinity of
re, heat and extensive temperatures over
+40°C.
Store these instructions carefully and, if
necessary, pass them on to other users.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Apa 16621 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Apa 16621 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2.99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info