801470
28
Zoom out
Zoom in
Previous page
1/37
Next page
DEUTSCH
BBA 240 | Bedienungsanleitung
54
55
Bedienungsanleitung | BBA 240
6 | FEHLERBEHEBUNG
PROBLEM LEDS LÖSUNG
Kein oder zu leiser Klangl LED POWER leuchtet
nicht
Vergewissern Sie sich, dass das Gerät
ordnungsgemäß an der Netzsteckdose
angeschlossen ist. Prüfen Sie, ob
der Spannungswahlschalter richtig
eingestellt ist. Prüfen Sie, ob der
Netzstecker fest in der Steckdose
eingesetzt ist.
LED POWER leuchtet,
jedoch GAIN des
Eingangskanals niedrig
eingestellt
GAIN-Pegel anheben
LED POWER leuchtet,
GAIN angehoben, aber
Taste MUTE gedrückt
MUTE-Taste lösen
LED POWER leuchtet,
jedoch VOL des
Eingangskanals niedrig
eingestellt
VOL-Pegel anheben
LED POWER leuchtet,
jedoch VOLUME der
Ausgangszonen niedrig
eingestellt
VOLUME der Kanäle anheben.
LED POWER leuchtet,
alle Bedienelemente
aktiv, aber Phantom
nicht aktiviert
Wahlschalter der Eingänge in mittlere
Position stellen, um die Phantom-
Versorgung zu aktivieren
Nach obigen Prüfungen
noch immer kein Ton
Anschlüsse zwischen Quellen und
Eingängen prüfen.
Verzerrung LED PEAK leuchtet in
einer Zone
GAIN des Eingangs herunterdrehen
Sicherstellen, dass kein Line-Signal an
einem MIC-Eingang anliegt
Quellenpegel überprüfen.
VOLUME der jeweiligen ZONE absenken
Rote LED aller ZONEN
leuchten permanent
GAIN/VOL des Eingangs und/oder
VOLUME der Zonen absenken
Breiiger Ton
Sicherstellen, dass nicht gleichzeitig
mehrere Signalquellen auf dem gleichen
Kanal aktiviert wurden
Vergewissern Sie sich, nicht mehrere
Lautsprecher für die gleiche Zone
angeschlossen zu haben
7 | TECHNISCHE DATEN
Eingangsanschlüsse CH1-4 - Kombi (XLR F + Klinke 6,35mm)
CH5 - Stecker
Tel - RJ11
Empndlichkeit der Eingänge CH1-4 - Mic/Phantom: -50dBV;
Line: -10dBV symmetrisch
CH5 - unsymmetrisch -10dBV
Tel - symmetrisch -10dBV
Signal/Rauschabstand Mic >65dB
Line >75dB
Tel >65dB
Anzeigen 5 MUTE LEDs für die Eingänge
1 PAIR LED für Bluetooth
4 Pegelanzeigen der Zonen
1 Pegelanzeige des Monitors
1 Einschalt-LED
Frequenzgang (-3dB) 60Hz-17KHz
Bedienelemente EQ - HIGH/LOW +/-10 @ 10KHz; +/-10 @ 100Hz
THD-Wert < 1%
Ausgangsanschlüsse Line, Monitor und Lautsprecher - Phoenix
Kopfhörer - Klinke 6,35mm
Ausgänge POWER AMP. OUTPUT Konstante Impedanz – 4Ω/8Ω
Konstante Spannung – 25V/70V/100V
Ausgangsleistung POWER AMP. OUTPUT 120W RMS x 4CH @ 4Ω
Ausgang MONITOR LINE OUT 1V (600Ω)
Ausgang MONITOR 1W8Ω 1W RMS
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ANT Bba 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ANT Bba 240 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 11.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info