681984

Angelcare AC310 Manual

9
Zoom out
Zoom in
Previous page
1/30
Next page
2.2 - SELECT THE CRIB LEG TO SECURE THE CORD COVERS
6
5
4
3
2
1
6
5
4
3
2
1
Figure 1 Figure 2
RECOMMENDED
OR
Use the crib leg by the wall closest to the Camera (Figure 1). In cases where the Camera is
across the room, use the leg closest to the Camera to position the covered wire (Figure 2).
It is always preferable that the covered cord run along a wall.
2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
Sensor Pad
6
5
4
3
1
2
2
3
1) Remove the mattress
from the crib.
2) Place the Sensor Pad –
printed side up – on top
of the hardboard.
3) Run the connection pin,
warning label and the
first 5 cord covers down
along the backside of
the crib leg, between
the mattress support
and the inside edge of
the crib.
IMPORTANT
If your crib does not have a stable surface for the sensor
pad, you will need to place a support under it. This
hardboard support should be at least ¼” (6 mm) thick and
should have minimum dimensions of 13” x 13” (33 cm x 33
cm). This support board must be larger than the Sensor Pad
surface area.
Hardboard
4
5
4) Bring the first 4 cord
covers down the floor,
and keep the 5th cord
cover vertically, along
the backside of the
crib leg, (between
the mattress and the
inside edge of the
crib).
5) Remove any cord slack
to make sure no parts
of the cord are loose.
9
E
N
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Angelcare AC310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Angelcare AC310 in the language / languages: English as an attachment in your email.

The manual is 4,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Angelcare AC310

Angelcare AC310 Quick start guide - English - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info