681983
17
Zoom out
Zoom in
Previous page
1/56
Next page
17
Care and Maintenance
Disconnect all units and remove all batteries before cleaning. Clean the exterior surface of the units with a
soft dry or slightly damp cloth. Do not spray with cleaning products or solvents.
Do not submerge in water or any other liquid.
During long periods of non-use, remove all batteries from their compartments and unplug the AC adapters.
Troubleshooting
Problem
Possible Cause
Solution
False alarms
Baby was removed from crib and the Nursery
Unit was not switched off.
The printed side of the Sensor Pad is not
facing up.
The Sensor Pad is not detecting your baby’s
movements because the sensitivity level is
too low.
Sensor Pad is not in full contact with the
crib mattress or is not resting on a flat, firm
surface.
Baby has moved far away from the Sensor
Pad.
Turn the Nursery Unit off.
Make sure the printed side is facing up.
The sensitivity level may need to be
increased.
Refer to the Movement Sensitivity
Adjustment section.
Make sure there is no bedding between
mattress and the Sensor Pad. The Sensor
Pad must rest on a completely flat and
firm surface. If the crib has a spring or slat
base, place a hard board between the crib
base and the Sensor Pad measuring at
least 13” x 13” (33x33 cm) and 1/4 inch
(6 mm) thick.
Make sure that the sensor pad is installed
as shown. The sensitivity level may also
need to be increased. Refer to the
Movement Sensitivity Adjustment section.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Angelcare AC201-2P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Angelcare AC201-2P in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info