541772
16
Zoom out
Zoom in
Previous page
1/20
Next page
SVT-4 PRO Bass Guitar Amplifier
16
Rack Mounting
When mounting the SVT-4 PRO into a rack, the four bottom feet should be removed
to maintain the three rack space height of the amplifier. Be sure to keep the feet and their
attachment bolts for future use. If the feet are reinstalled, never use screws which will
protrude farther into the amplifier than the original hardware.
The rack must be a high quality enclosure capable of securely supporting the weight
of the amplifier. Tighten the mounting screws securely through the amplifier’s face plate,
into the rack rails. Check the rack and mounting screws occasionally to ensure a continually
safe and secure installation.
Thermal Considerations
The amplifier is fan cooled with one large fan. Air is drawn through the rear panel vent
to cool down the amplifier heatsinks, and then expelled through the side panel vents.
When installing, be sure to allow sufficient air space around the front, sides and rear of the
amplifier for adequate cooling for the heatsinks. Leave at least one rack space above and
below, and at least six inches behind and in front of the chassis to allow proper ventilation.
The rear of the rack should be unobstructed and placed no closer than 10" from walls or
other large obstructions. When the amplifier is first turned on, the fan runs at a low speed.
As the power output increases and the amp warms up, the fan gradually increases in speed
to provide additional cooling. If the amplifier should overheat, a thermal switch turns off the
power amplifier, allowing the heatsink to cool down. Once the amplifier has cooled to a safe
operating temperature, the thermal switch resets and reactivates the amplifier. If this
should occur, identify the cause of the problem and take corrective action. For example:
•Providebetterventilation
•Installafanintheracktomovemoreair
•Makesuretheamplifierisnotoverloadedwithtoolowofaloadimpedanceorbya
short circuit on the speaker line
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ampeg SVT-4 Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ampeg SVT-4 Pro in the language / languages: English as an attachment in your email.

The manual is 2,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info