Manual Amica UKS 16157 (page 71 of 100) (English, German, Dutch, French)

722360

Zoom out

Zoom in

1/100

WARRANTYANDAFTER-SALESERVICES

Warranty

Warranty service as stated on the warranty card

The manufacturer shall not be held liable for any damage caused by improper use of the product.

CHANGINGTHEDIRECTIONOFTHEDOOROPENING

The door of the refrigerator can be opened both from the left or right as required. The following are the

steps required to position the door to open to the right.

Remove the lower bracket (1) on the right, the door and the screw hole cover (4). Remove the lower

bracket pivot (3) and the spring washer (2), and then place and x them in the hole on the left of the lower

bracket. Remove the cover (5) on the upper brackets on both left and right sides; remove the bracket pivot

on the right side and the spring washer and then x them in the bracket hole. Install the door between

the upper and lower brackets on the left and fasten the lower bracket by tightening the screws. Install the

screw hole cover in the lower bracket hole on the right, and then install the upper bracket covers on the

upper brackets on the left and right. After installation open and close the door to ensure the door operates

correctly. Move the components (7) and (8) with the special tool provided. Remove the screw (9) from the

refrigerator, open the door fully and replace screw (9) in the corresponding opposite position. Remove

and replace component (10), at the corresponding position on the left, with the special tool provided. Fix

component (7) in the corresponding opposite position.

Ventilation

Level the kitchen cabinet unit with a spirit level and a try square. Level the unit by placing packing mate-

rial underneath if required. A minimum gap of 38mm must be maintained at the back of the appliance for

ventilation. Air inlet A must be at least 200 cm square and air must ow through the panel in the cabinet

plinth. Check that the position of the power socket (1) is correct. Mains voltage where the appliance is to

be used must comply with that shown on the data plate located on the left inside wall of the appliance next

to the vegetable bins. The power supply must be suitably earthed.

INSTALLATION OF THE APPLIANCE

Installation of the appliance should be performed by a qualied installer. The appliance should be placed

in furniture case. Run the mains cable through the unit such that it can be connected to the power supply

after installing the appliance. Remove the cover (6) only if space is restricted. Place the refrigerator into

the kitchen unit. Fix the brackets (1) with screws (2) onto the upper frame when two third of the refrigerator

has been inserted. Then insert the refrigerator in completely, ensuring that the gib clamp of the brackets

stuck on the horizontal frame of the kitchen unit. Adjust the position of the refrigerator making a 6mm spa-

ce between inside wall of the kitchen unit and external sides of the refrigerators. Fix the brackets to the

horizontal frame of the kitchen unit with screws. Insert the seal in the aperture (approx. 10mm) between

the lower front frame and bottom board of the kitchen. Fix lower brackets (3) to the lower front frame with

screws (2). Fix the lower brackets to the bottom board of the kitchen unit with screws (2). Properly insert

seals in the apertures on the left, upper and right sides of the refrigerator.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Amica UKS 16157 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,08 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Amica UKS 16157 Manual

Product: