540025

Amica OSC 5458 I Manual

4
Zoom out
Zoom in
Previous page
1/4
Next page
VI Operation and maintenance
1. Operational safety.
All safety instructions included in chapter IV must be observed. Textile grease filters and
carbon filters should be replaced and aluminium filter should be cleaned according to
manufacturer’s instructions, or more frequently in periods of intensive use (more than 4 hours
a day). If a gas cooker is used it is forbidden to leave uncovered flame. When removing pots
from gas burners set the flame to its minimum level. Always make sure that flame does not
extend outside the pot. Such a situation causes undesired energy losses and dangerous heat
build-ups. The hood should not be used for other purposes than those for which it was
designed.
2. Operation:
2.1 Control panel
Fig. 4
Operation of the hood can be controlled by means of switches „W” and „O” (Fig. 4):
- switch „O” controls lighting. Shifting the switch to the left turns the lighting on, to the right
- turns the lighting off.
- switch „W” is used to control the hood motor. Successive shifts to the left turn on three fan
operation speeds. These control options enable the user to set the optimum fan speed for his
requirements at minimum noise.
3. Maintenance.
Regular maintenance and cleaning of the device will guarantee its good and fault-less
operation, and extend its life. Attention should be paid to replacing grease and carbon filters
according to instructions.
3.1 Grease filter
a) replacement
The grease filter should be replaced at least every two
months during normal operation of the hood. The filter
can be dismantled by releasing its securing studs (Fig. 5),
keeping in mind that the filter has to be protected with
your hand during releasing the studs, removing catches D
which secure the filters (Fig. 6), then you can replace the
filter and reinstall the catches and the mesh.
Fig. 5
3.2 Carbon filter
a) operation
Carbon filters (C Fig. 6) can absorb odours
until they are saturated. They cannot be
washed or regenerated and should be
replaced at least every 2 months or more
frequently in case of very intensive use.
b) replacement
- remove masking cover A (Fig. 6) together
with grease filter B,
- replace carbon filter C situated on the
textile filter B,
Fig. 6
- install the grease filter with the carbon filter in the hood.
3.3 Lighting
The lighting system consists of 40 W power light bulb.
To replace a light bulb proceed as follows:
a) remove the masking cover A from the hood body (see section 3.1 a)
b) replace the bulb using a piece of cloth or paper for that purpose,
c) install the masking cover A.
3.4 Cleaning
When cleaning your hood never use:
- solvents or alcohols which might dull lacquered surfaces
- caustic or abrasive substances, particularly for cleaning stainless steel surfaces
It is recommended to us moist cloth and liquid neutral cleaning agents.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amica OSC 5458 I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amica OSC 5458 I in the language / languages: English as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info