794739
9
Zoom out
Zoom in
Previous page
1/16
Next page
9
Setting the ventilation hood in the scent absorber mode
Inthismode,airlteredthroughtheactivecarbonlterreturnstotheroombytheoblong
openings of the cleaned air outlet located on the upper masking element.
If the ventilation hood is to be used in this mode, it is necessary to purchase and install an
activecarbonlter.
INSTALLATION
1.Fixthewallsectionoftheventilationhoodtothewall,usingxingpinsandscrewsfrom
the installation packet*, at a height so that the suspended ventilation hood in on the level of
650-750 mm over the top of the stove.
2.Removethefatlteroftheventilationhood(thenumberofltersde-
pends on the type of the hood) by unfastening the snap fastener.
3. The hood must be placed with its installation opening in the back against
the wall over the installed wall section so that the upper edge of the opening
slides into the wall section (see the drawing beside).
4. The ventilation hood should then be leveled using a hand level and, if necessary, its po-
sition should be corrected by screwing in or out of the leveling screws located on the body
of the hood over the installation opening. After the ventilation hood is leveled, a securing
screw should be screwed in in the middle of the wall section.
5. At the required height, in the ventilation hood axis of symmetry, install the grip of the
chimney masking element along with the air guide.
GOOD BAD
* Before installation, it is customer/ installer obligation to check if supplied installation
elements are suitable for the wall of installation, and if wall’s construction will hold screws
correctly.
If provided screws are incorrect, it is customer responsibility to purchase suitable ones.
Manufacturer shall not hold responsibility for any damage, occurred in the effect of impro-
per screws used.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amica OKF921G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amica OKF921G in the language / languages: English as an attachment in your email.

The manual is 1.16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info