Manual Amica EKGC 16155 (page 24 of 108) (English, German, Dutch, French)

722226

Zoom out

Zoom in

1/108

INSTALLATION AND OPERATING CONDITIONS OF THE APPLIANCE

* Only free- standing appliances

** According to the model

Installation before using the appliance

for the rst time

● Take the product out of the package,

remove the scotch tape protecting the

door and the equipment. Any remaining

adhesive stains may be removed with a

mild washing agent.

● Do not throw away the polystyrene ele-

ments of the packaging. If it is necessary

to transport the fridge-freezer, pack it in

the polystyrene elements and lm as well

as protect ing it with scotch tape

● Clean the interior surface of the fridge-

freezer and the elements of the equip-

ment with a washing agent dissolved in

lukewarm water, then wipe it dry.

● Place the fridge-freezer on an even, at

and stable surface, in dry, aired and

shaded room, far from the heat sources

such as: oven, hob, central heating ra-

diators, central heating pipes, hot water

installation, etc.

● On the exterior surface of the product

may be a protective foil, this foils should

be removed.

● Make sure the appliance is placed in a

horizontal position by screwing in the 2

adjustable front legs (g. 3)

● To ensure that the door opens freely, the

distance between the side of the applian-

ce (on door hinges side) and the wall is

shown on gure 5.*

● Ensure adequate ventilation of the room

and free air circulation from all sides of

the appliance (g. 6).*

Minimum distances from the heat sources

- from the electric gas and other ovens -

30 mm,

- from oil or coal red ovens - 300 mm,

- from built-in ovens - 50 mm

If there is no possibility of ensuring the

above- mentioned distances, provide an

appropriate insulation board.

● The rear wall of the refrigerator, in parti-

cular, the condenser and other elements

of the cooling system must not contact

other elements, which may damage

them, (e.g. central heating pipes and the

water supply pipes).

● It is forbidden to readjust or modify

any parts of the unit. It is crucial not to

damage the capillary tube visible in the

compressor recess. The tube may not

be bent, straightened or wound.

● If the capillary tube is damaged by the

user the guarantee will be void (g. 8).

● In some models the handle is put into

the appliance, You should screw it with

Your own screwdriver,

Mains connection

● Prior to connection, it is recommended

to set the temperature control knob to an

„OFF” or other position that disconnects

the appliance from the power supply

(See page with the control description).

● This appliance should be connected to

AC 220-240V 50Hz supply socket. The

socket must be tted properly, and must

be supplied with an earthing conduit and

a 10A fuse.

● It is a legal requirement that the applian-

ce is properly earthed. The manufacturer

will not be held liable for any damage or

injury which may result from the failure

to full this requirement.

● Do not use adapters, multiple sockets

and two-wire extension leads. If it is

necessary to use the extension lead, it

must be equipped with a protection ring

and a single socket and must have a

VDE/GS safety certicate.

● If an extension lead is used (with a

protection ring and safety certicate), its

socket must be located at a safe distan-

ce, away from the sinks, and must not

be in a place where it could be ooded

by water or waste water.

● See the type plate at the lower part of the

internal wall of the appliance for detailed

specications**.

Disconnecting the mains

● Make sure the appliance can be easily

disconnected from the mains, either by

pulling the plug out of the mains socket,

or by switching the two-pole switch o󰀨

(g. 9).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Amica EKGC 16155 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Amica EKGC 16155 Manual

Product: