794706
39
Zoom out
Zoom in
Previous page
1/44
Next page
39
OPERATION IN CASE OF EMERGENCY
In the event of an emergency, you should:
switch off all working units of the cooker
disconnect the mains plug
call the service centre
some minor faults can be xed by referring to the instructions given in the table below.
Before calling the customer support centre or the service centre check the following points
that are presented in the table.
PROBLEM POSSIBLE CAUSE REMEDY
1.The appliance does not
work
- no power -check the fuse, replace if
blown
2.Sensor elds do not re-
spond when touched
- appliance is not turned on - turn on the appliance
- sensor eld touched
too briey (less than one
second)
- touch the sensor eld
longer
- multiple sensors touched
at the same time
- always touch only one
sensor eld (except when a
cooking zone is switched off)
3.the programmer display is
ashing “0.00”.
-the appliance was disconnec-
ted from the mains or there was
a temporary power cut.
-set the current time
(see ‘Use of the programmer’).
4. the oven lighting does not
work
-the bulb is loose or damaged -tighten up or replace the blown
bulb (see Chapter Cleaning and
Maintenance)
5.The induction hob does not
respond and beeps briey
- child lock feature is active - deactivate child lock
feature
6.The induction hob does
not respond and emits and
extended beep
- improper use (wrong
sensor elds touched or
sensors touched too briey)
- reconnect the hob
- sensor elds covered or
dirty
- uncover or clean the sen-
sor elds
7.The induction hob switches
itself off
- no sensor eld is touched
for 10 seconds of activating
the appliance
- switch on the appliance
and set heat setting without
delay
- sensor elds covered or
dirty
- uncover or clean the sen-
sor elds
8.A single cooking zone swit-
ches off and residual heat
indicator „H” is shown.
- limited cook time - switch on the cooking zone
again
- sensor elds covered or
dirty
- uncover or clean the sen-
sor elds
- electronic components
overheated
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amica 608DIE2TABM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amica 608DIE2TABM in the language / languages: English as an attachment in your email.

The manual is 1.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info