©American Audio® - www.americanaudio.eu VMS4.1™ User Manual Page 31
(25) CF Assign A & B – CF Assign A will select the desired channel to the left side of the crossfader.* CF Assign B will select the desired channel to
the right side of the crossfader.*
* Normal Mode: This will be the opposite when the crossfader is reversed.
* The Crossfader will only affect a channel's volume when the channel is assigned.
12.2.3 INTERFACE MODE (26-28)
The VMS4.1™ can be used as a MIDI control, a stand-alone mixer, or combination giving you maximum control of your music collection whether it
be on vinyl, digital CD's or Computer DJ software (Virtual DJ LE included).
(26) 4 OUT: 4 OUT X 4 IN USB – Sets MIDILOG channels 2 & 3 to receive audio from software with ASIO outputs and sends audio or control tones
from the channel 2 & 3 RCA inputs to your software ASIO inputs.
(26) 8 OUT: 8 OUT X 2 IN USB – Sets 4 MIDILOG channels to receive audio from software with ASIO outputs and sends the audio from the master
output via USB for recording.
(27) Normal/Reverse – Switches the crossfader from normal to reverse mode. In reverse mode the CF A assignments will be on the right of the
crossfader and the CF B on the left.
(28) Curve Knob – This knob will adjust the curve of the crossfader from mix curve, dipped curve, to scratch curve.
12.2.3 HEADPHONES CONTROLS (28-30)
(29) Cue/Master Knob – Sets the headphones output from Cue or Master. When set to the Cue position, the headphones will receive the signal
from any and all channels with the Cue button activated. When set to the Master position, the headphones will receive the pre-fader master
output signal, allowing you to cue the master at any output level and even if it is fully off. Any knob settings in between Cue and Master will blend
the Cue and Master signals.
