603201
27
Zoom out
Zoom in
Previous page
1/55
Next page
©American Audio® - www.americanaudio.eu VMS4.1™ User Manual Page 27
Cue Buttons These buttons are used to activate a channels Cue mode. The Cue LED will glow when a channels cue mode is activated. The
Cue function sends a channels incoming signal to the headphones. The cue level is adjusted by the Cue Level Knob. Note: The MIDILOG CUE
Button has an additional function. During power-on, hold this button down to toggle the post EQ mode on and off. For more on this please
refer to chapter EQ Modes on page 39.
(5) Mouse Pad This will function as a normal mouse pad on laptop would function. The Load Buttons underneath are the left and right click
buttons. When any of the Shift Buttons are active (LED lit) the mouse pad is disabled and is able to send MIDI messages. Adjustments to the
mouse pad can be made in the Control Panel (PC) or Utilities (Mac).
(6) Master Volume, Balance & Booth Controls
Master Volume Control This knob is used to control the master output level. To avoid distorted output try to maintain an average output
signal level no greater than +4dB. To avoid speaker damage that may be caused by excessive volume, be sure this knob is always set to zero
(completely down) before turning the unit on.
Master Output Balance Control This knob is used to control the pan, adjust how much of the signal is sent to the left and right output
level. For true stereo imaging, maintain the knob in the 12 o’ clock position.
Booth Level This knob is used to adjust the monitor volume output level. Turn the knob in a clockwise direction to increase the monitor
volume.
(7) Channel Volume Level Indicators The LED indicators that run along each channels EQ section are used to measure incoming signal levels. Use
these indicators to visually maintain an average signal output of +4dB. A consistent average output level of +4dB will produce a clean output
signal. When no Cue sources are selected, these indicate the volume level on the Master Output. When one or more Cue sources are selected,
these indicate the volume level on all of the Cue sources combined. At power-on, these indicate the VMS4.1 firmware version. If the left side
lights up 1 LED and the right side lights up 3 LEDs, the firmware version is 1.3.
(8) Crossfader This fader is used to blend the output signals of Channels A and B together. When the fader is in the full left position (Channel A),
the output signal of Channel A will be controlled by the master volume level. The same fundamentals will apply for Channel B. Sliding the fader
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for American Audio VMS4.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of American Audio VMS4.1 in the language / languages: English as an attachment in your email.

The manual is 1,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of American Audio VMS4.1

American Audio VMS4.1 User Manual - German - 56 pages

American Audio VMS4.1 User Manual - Dutch - 30 pages

American Audio VMS4.1 User Manual - French - 28 pages

American Audio VMS4.1 User Manual - Spanish - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info