603200
10
Zoom out
Zoom in
Previous page
1/22
Next page
©American Audio® - www.americanaudio.us - 19MXR Instruction Manual Page 10
access the buttons secondary command Load selected song to secondary Right deck.
ENCODER & PUSH ACTION - Turn the encoder to increase or decrease the selected action. Pushing
down on the encoder activates an action. See the navigation buttons for more info.
UP (MIDI) - This control will set focus on the Left deck FX unit. The Encoder will set the amount for Param-
eter 1 on the Left FX unit; the SHIFT BUTTON + the ENCODER will set the amount for Parameter 2; and
pushing the ENCODER will turn the FX on/off.
FWD (MIDI) - This control will set focus on the Song browser. The ENCODER will browse up/down the
song list.
DOWN (MIDI) - This control will set focus on the Right deck FX unit. The Encoder will set the amount for
Parameter 1 on the Right FX unit; the SHIFT BUTTON + the ENCODER will set the amount for Parameter 2;
and pushing the ENCODER will turn the FX on/off.
BACK (MIDI) - This control will set focus on the Folder browser. The ENCODER will scroll up and down
the Folder browser, pressing the ENCODER down will open or close Folders/Devices.
FILTER - Push the Knob in to enable and disable the LPF/HPF lter. The LED indicator will glow when the
lter is On. The center position for the Filter is neutral so the signal is will not be ltered. Turn the knob to
the left from the neutral position to set the low pass lter, this will cut off all frequencies higher than the
amount set on the lter. Turn the knob to the right from the neutral position to set the high pass lter, this
will cut off all frequencies lower than the amount set on the lter.
NOTE: The Filter is assigned via the corresponding FADER ASSIGN KNOBS (15), i.e. Filter A is assigned
using Deck A FADER ASSIGN KNOB (15). The LED indicator will blink when the lter is enabled but the
FADER ASSIGN KNOB (15) is set to the Off position.
SHIFT (MIDI) - The button has 2 functions a soft and a hard shift. A soft shift is performed by toggling
the shift button, this will be indicated by a blinking shift LED. A hard shift is performed by holding down
the shift button and combining it with another button.
NOTE: When performing a hard shift, it’s recommended you release the secondary button before releas-
ing the Shift button, this is to prevent MIDI latches unless the MIDI function is a temporary function.
6. CUE LEVEL VOLUME CONTROL - Thisknobisusedtoadjuststheheadphonevolumeoutputlevel.Turn
theknobinaclockwisedirectiontoincreasetheheadphonevolume.
7. MASTER VOLUME CONTROL - Thisknobisusedtocontrolthemasteroutputlevel(mainvolume).Toavoid
distortedoutputtrytomaintainanaverageoutputsignallevelnogreaterthan+4dB.(seeChannelGain2)To
avoidspeakerdamagethatmaybecausedbyexcessivevolume,besurethisknobisalwayssettozero(com-
pletelydown)beforeturningtheuniton.
8. BOOTH LEVEL - ThisknobisusedtoadjuststheBoothvolumeoutputlevel.Turntheknobinaclockwise
directiontoincreasethemonitorvolume.
9. CONTROLLER MODE - Thismixerhastwooperatingmode;Mixermode(default)andControllermode.
ToactivateControllermode,holddowntheControllerModeButtonwhenpoweringupbeforetheVUmeter
displaystheFirmwareVersion.TheLEDwillglowwhenControllerModeisactivated.Toexitthismode,power
down,thenpowerupwhileholdingtheControllerModebutton.
MixerMode-ThismodewillroutetheUSBaudiostreamto2Mixerchannels,MIDILOG2and3bydefualt.
NOTE: Set your software audio routing to External mixer. Set Deck A to USB 1+2, Deck B to USB 3+4.
Set MIDILOG channels 2 and 3 to USB.
ControllerMode-ThismoderoutestheUSBaudiostreamstotheMXRmixersmasterandheadphone
outputs.
NOTE: Set your software audio routing to Headphones. Set the Master to USB 1+2 and the Headphones
to USB 3+4.
SAMPLER - VirtualDJhasabuiltinSampler.Samples1-3arestoredunderCuebuttons1-3locatedonthe
19MXR CONTROLS AND FUNCTIONS cont.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for American Audio 19 MXR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of American Audio 19 MXR in the language / languages: English as an attachment in your email.

The manual is 3,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of American Audio 19 MXR

American Audio 19 MXR User Manual - German - 24 pages

American Audio 19 MXR User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info