337384
4
Zoom out
Zoom in
Previous page
1/320
Next page
4
How to Remove and Replace Doors and Hinges
Installing Your Refrigerator
Contact a qualified engineer to perform this task.
These instructions were provided to aid you in the installation of your unit. The manufacturer cannot be responsible for
improper installation.
Steps to Follow...
A qualified engineer must connect refrigerator in accordance with these installation instructions. Measure door opening
and depth and width of refrigerator. Remove handles or doors if required. Engineer must also do the following:
1. Follow local water and electrical company connection regulations.
2. Complete water supply connection before electrical supply connection.
Service to or replacement of power cord must be performed by a qualified servicer.
Installation Requirements
1. Install on an earthed outlet with a separate 230-240 volt, 50hz., 10A circuit Y-connection type power cord.
2. Protect soft flooring with cardboard or rugs.
3. Install on a floor which supports up to 429 kg.
4. Provide 5 mm clearance at side of refrigerator and for models more than 60 cm deep, provide 12.7 mm clearance at top
of refrigerator.
5. 60 cm deep models.
Trim corners of counter top to a 45° angle if counter top has 25 mm overhang.
Provide 5 mm clearance on both sides of refrigerator, and allow 7 mm on top for ease of installation and leveling.
No minimum clearance is required at the rear of the cabinet.
How to Remove Wooden Base
CAUTION!
To avoid personal injury or property damage, two people must remove wooden base.
1. Tape doors shut to prevent doors from opening unexpectedly.
2. Slide appliance cart under side of refrigerator.
3. Wrap refrigerator with blanket or pad. Thread strap around refrigerator. Put foam shipping pads, located in shipping
carton, under strap. Tighten strap securely.
4. Lower appliance cart to floor with appliance cart handles on bottom.
5. Remove top two bolts from skid.
6. Return refrigerator and appliance cart to an upright position. Remove strap.
7. Slide appliance cart under opposite side of refrigerator.
8. Repeat steps 3–5.
9. Remove wooden base.
10. Return refrigerator and appliance cart to an upright position and remove appliance cart.
IMPORTANT:
Do not leave refrigerator on its side longer than necessary to remove bolts.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amana xrss 264 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amana xrss 264 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 18,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info