337385
23
Zoom out
Zoom in
Previous page
1/320
Next page
23
Before Calling Service
OPERATION (continued)
TOPIC POSSIBLE CAUSE SOLUTION
Controls need to be adjusted.
See the controls section in your Owner’s Manual for
assistance in how to adjust your controls.
Refrigerator is not level. See
Installation Instructions
for
details on how to level your unit
Check for internal obstructions that are keeping door
from closing properly (i.e. improperly closed drawers,
ice buckets, oversized or improperly stored containers
or foodstuffs, etc.).
Refrigerator runs too
frequently (continued)
Door is not closing properly
Check gaskets for proper seal. Clean, if necessary,
according to cleaning instructions in Owner’s Manual.
ICE & WATER
Water appears cloudy
Air or air bubbles in water. This is normal when first using dispenser and will
disappear with use.
Carbon dust from water filter cartridge. Initial water ejected through cartridge may contain
harmless carbon dust flushed from cartridge. Particles are
safe for consumption. Will disappear after the first few
uses.
Particles in water and/or
ice cubes.
Concentrations of minerals in water will
form particles when water becomes frozen
and melts.
Particles are not harmful and naturally occur in
water supplies.
Freezer door is not closed.
Verify that freezer door is closed. Power is removed from
the control when freezer door is opened.
Refrigerator is not plugged in. Plug in unit.
Fuse is blown, or circuit breaker needs to
be reset.
Replace any blown fuses. Check circuit breakers for any
tripped circuits.
No indicator lights are lit
on dispenser control
(some models)
Power outage has occurred. Call local power company listing to report outage.
Freezer door is not closed. Verify that freezer door is closed. Power is removed from the
control when freezer door is opened.
Controls are in lock mode. See Dispenser control instructions.
Water tank is filling. At initial use, there is an approximate 45-second delay in
dispensing while the internal water tank is filling.
Ice maker or ice maker-equipped unit has just
recently been installed or a large amount of ice
has just been used.
Wait 24 hours for ice production to begin and for ice maker to
restock after emptied.
Neither ice nor water is
dispensed when pads are
pushed (some models)
Water filter is clogged or needs to be changed. Change water filter.
Ice maker has just recently been installed or a
large amount of ice has just been used.
Wait 24 hours for ice production to begin and for ice maker to
restock after emptied.
Water pressure is too low. Low water pressure can cause valve to leak. Water pressure
must be between 20 to 100 pounds per square inch to function
properly. A minimum pressure of 35 pounds per square inch is
recommended for units with water filters.
Ice maker is not producing
enough ice or ice is
malformed (some models)
Water filter is clogged or needs to be changed. Change water filter.
Ice maker arm is not in correct position Confirm ice maker arm is down. See
Automatic Ice Maker
section in your Owner’s Manual for details.
Household water supply is not reaching
water valve
Check water connection procedure in your
Installation
Instructions
.
Water supply tubing has kinks. Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Water pressure is too low. Water pressure must be between 20 to 100 pounds per square
inch to function properly. A minimum pressure of 35 pounds
per square inch is recommended for units with water filters.
Check freezer temperature. See the controls section in your Owner’s Manual for assistance
on how to adjust your controls. Freezer must be between 0 to
F (-18 to –17°C) to produce ice.
Ice maker is not producing
ice (some models)
Ice bin is not installed properly See ice bin section for proper installation and alignment.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amana xrss 264 rvs at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amana xrss 264 rvs in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 18,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info