342869
4
Zoom out
Zoom in
Previous page
1/180
Next page
4
10. Reverse door stops.
Locate door stop
(B)
at bottom edge of refrigerator
door
(A)
. Unscrew two Phillips screws to remove
door stop. Remove the two Phillips screws on
opposite edge of door. Mount door stop on
opposite side. Replace remaining screws in empty
mounting holes.
Repeat the above instructions to reverse door stop
on freezer door.
A
B
11. Reverse doors by performing the following steps:
Remove plugs and screws in opposite side of
refrigerator cabinet. Insert in holes left from hinge
removal.
12. Mount bottom, center, and top hinges with shims on
opposite side of cabinet.
Replace bottom hinge on opposite side of cabinet.
Verify hinge shims are in position before screwing
into place. After placing hinge pin into outside
hole, replace round shims. Some bottom hinges
may have plugs in holes. In case of this, remove
plug from outside hole, put pin in hole, and replace
plug in empty hole.
Replace top hinge and shims, but allow enough
clearance to slide hinge side of refrigerator door
into place. Tighten down top hinge to securely hold
door.
Space door
11
/
16
"(18 mm) from cabinet.
Handle side of door should be approximately
1
/
8
" (3 mm) higher than hinge side. Door will
become level when it is loaded with food.
11/16"
(18 mm)
1/8"
(3 mm)
13. Mount refrigerator handle on opposite side of door
using mounting screws removed in previous step.
Snap handle trim into place and replace screw.
14. Mount freezer handle to opposite side of door using
mounting screws removed in previous step.
Angle front edge of handle cap downward
toward back lip of freezer handle. Verify
bottom tab on freezer cap slides under rear lip
of freezer handle. Snap rear edge of handle
cap in place.
15. Check unit for proper leveling following instructions in
starting with step 5.
16. Replace toe grille and bottom hinge cover.
Important: Look for arrow printed on inside of grille
to insure proper placement.
Snap top portion into place first. Press down on
lower part of grille until bottom portion snaps into
place.
3. Move refrigerator into final location.
CAUTION
!
Protect flooring with cardboard, rugs or other protective
material to avoid property damage.
4. Plug in power cord.
Power cord must be serviced only by a qualified
service personnel. Special tools are required to
service equipment. Contact nearest authorized
service facility for examination repair or adjustment.
5. Level refrigerator.
a.Turn roller adjustment screw
(A)
right to raise cabinet,
and left to lower cabinet.
b.Adjust stabilizing leg
(B)
to support refrigerator firmly
against floor.
CAUTION
!
To avoid personal injury or property damage caused by
refrigerator tipping, stabilizing leg must be firmly against
floor.
A
B
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amana bx 518 vw ve at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amana bx 518 vw ve in the language / languages: English as an attachment in your email.

The manual is 13,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info