682705
8
Zoom out
Zoom in
Previous page
1/16
Next page
8
english
ATTACHING THE LAP BELT
The lap belt should be attached to the chair,
if this is not the case, slip the narrow
end of the belt through the D ring at the rear
of the seat base (14). Pull the lapbelt to the
front (15). Adjust the position of the belt by
using the sliding adjustment mechanism on
the front of the belt. Where possible have the
catch in the mid-line position. Please ensure
that the lap belt is correctly adjusted before
use, if in doubt call your supplier.
LAP BELT
To avoid risk of injury, it is very important that
these instructions are followed carefully. The
lap belt supplied should only be used with
the Pixi. To adjust the straps, sit the user
in the chair, wearing the clothes that would
be appropriate for the season. Where pos-
sible, adjust the straps so that the xing is
in the mid-line position; tension the straps
on the sliding adjusters (Tri-Slides) by pull-
ing the strap outwards, away from the cen-
tre of the chair, and then re-position the Tri-
Slide. Move the belt in the opposite direction
to slacken. Ensure that the straps are tight
enough to stop a child sliding through the
seat, but also check that they are comfort-
able and not causing distress. Re-tighten or
loosen the straps depending on the environ-
ment. For optimal positioning try to achieve
a 45º angle at the hip. Please check that the
straps are correctly adjusted and positioned
every time you use the Pixi. Never leave
your child unattended in the chair.
svenska
FASTSÄTTNING AV MIDJEBÄLTE
Midjebältet ska fästas på vagnen, om det inte
redan är gjort. Trä den smala änden av bältet
genom ”D”- ringen på baksidan av sitsen (14).
Dra midjebältet till framsidan (15). Justera
läget på bältet med justeringsmekanismen på
framsidan av bältet. Försök om möjligt att få
låset att hamna i mitten (16). Se till att bältet
är korrekt justerat innan användning. Vid tvek-
samhet kontakta er leverantör.
MIDJEBÄLTE
För att undvika skada, är det väldigt viktigt att
dessa instruktioner följs noggrant. Det medföl-
jande midjebältet skall endast användas till-
sammans med Pixi. För att justera bältet plac-
eras brukaren i vagnen, med de kläder som
är lämpliga för klimatet. Om möjligt så justera
remmarna så att låset hamnar i mitten. Spänn
åt remmarna på glidjusterarna (Tri-Slides)
genom att dra i remmarna utåt, bort från cen-
trum av vagnen och sen åter positionera ”Tri-
Slides”. För bältet åt andra hållet för att släppa
på spänningen. Se till att remmarna är tillräck-
ligt spända för att förhindra barnet att glida ur
sitsen, men samtidigt sitter behagligt och inte
orsakar obehag. Spänn åt eller lossa på rem-
marna beroende på omständigheterna. För
optimal positionering försök att uppnå 45º vin-
kel vid höften (18). Kontrollera att remmarna
är korrekt justerade varje gång Pixi används.
Lämna aldrig barnet obevakat i vagnen.
x 2
14 15
16
17
18
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alvema Pixi S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alvema Pixi S in the language / languages: English, Swedish as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info