661026
98
Zoom out
Zoom in
Previous page
1/103
Next page
98-EN
Disc playback sound skips due to vibration.
Improper mounting of the unit.
- Securely re-mount the unit.
Disc is very dirty.
- Clean the disc.
Disc has scratches.
- Change the disc.
The pick-up lens is dirty.
- Do not use a commercially available lens cleaner disc. Consult
your nearest Alpine dealer.
Disc playback sound skips without vibration.
Dirty or scratched disc.
- Clean the disc; a damaged disc should be replaced.
CD-R/CD-RW/DVD-R/DVD-RW/DVD+R/DVD+RW playback
not possible.
Close session (finalisation) has not been performed.
- Perform finalisation and attempt playback again.
Error displays.
Mechanical error.
- Press . After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the
problem, consult your nearest Alpine dealer.
MP3/WMA/AAC is not played back.
Writing error occurred. The CD format is not compatible.
- Make sure the CD has been written in a supported format.
Refer to “About MP3/WMA/AAC” (pages 93 to 94), then
rewrite in the format supported by this device.
Unit does not operate.
Condensation.
- Wait a while (about 1 hour) for the condensation to dry.
Playback does not start.
Disc is loaded upside-down.
- Check the disc and load it with the labelled side facing upward.
Disc is dirty.
- Clean the disc.
A disc not able to play back with this unit is loaded.
- Check if the disc is able to be played back.
Parental lock is set.
- Cancel the parental lock or change the rating level.
Picture is unclear or noisy.
Disc is being fast-forwarded or fast-reversed.
- The picture may be slightly disturbed, but this is normal.
Vehicles battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
Image stops sometimes.
Disc is scratched.
- Replaced with a non-scratched disc.
Navigation
The Navigation cannot work properly.
Reset Navigation system.
- Reinsert the SD card and turn the ignition key off, and then set
to ON again.
If this Message Appears
Various messages are displayed on the screen during operation. In
addition to the messages telling you the current status or providing
guidance for the next operation, there are also the following error
messages. If one of these error messages is displayed, carefully follow the
instructions in the solution column.
System
If you are driving, please pull over before using this function.
A setup operation, etc., was carried out while the vehicle was
running.
- Move the vehicle to a safe location, stop, and engage the
parking brake, then carry out this operation.
USB current error.
Abnormal current is run to the USB connector device.
- Turn the ignition key off, and then set to ON again.
- Attempt to connect another iPod/iPhone/USB Flash drive.
USB HUB is not supported.
A USB flash drive with a hub is connected.
- You cannot play back from a USB flash drive with a hub. USB
hub connections are also not supported.
Audio/Visual
Connected USB device is not supported.
An iPod/iPhone that is not supported by the unit is connected.
- Connect an iPod/iPhone that is supported by the unit.
- Reset the iPod.
A USB device that is not supported by the unit is connected.
- Attempt to connect another USB flash drive.
Communication error.
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPod/iPhone
and the unit, using the iPod/iPhone cable.
- Check the display by reconnecting between the USB flash drive
and the unit.
Caused by the iPod/iPhone Software Version not being
compatible with this unit.
- Update the iPod/iPhone Software Version to be compatible
with this unit.
The iPod/iPhone is not verified.
- Change to another iPod/iPhone.
No data.
There are no data in the iPod/iPhone.
- Download data to the iPod/iPhone and connect to the unit.
There are no data in the USB flash drive.
- Download data to the USB flash drive and connect to this unit.
Un-readable song was skipped.
A copy-protected WMA file has been detected.
- You can only play back non-copy-protected files.
A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate supported by the unit.
DAB Antenna error
The DAB antenna cable is either damaged or not connected
correctly to the product.
- Check that the antenna cable is not kinked or otherwise
damaged. Replace the antenna if necessary.
98


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine X701D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine X701D in the language / languages: English as an attachment in your email.

The manual is 4,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alpine X701D

Alpine X701D Additional guide - English - 84 pages

Alpine X701D Quick start guide - English - 188 pages

Alpine X701D Additional guide - German - 90 pages

Alpine X701D User Manual - German - 103 pages

Alpine X701D Quick start guide - German, Dutch - 188 pages

Alpine X701D Additional guide - Dutch - 85 pages

Alpine X701D User Manual - Dutch - 103 pages

Alpine X701D Quick start guide - French, Italian, Polish, Swedish, Spanish - 188 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info