660389
41
Zoom out
Zoom in
Previous page
1/50
Next page
41-EN
In Case of Difficulty
If you encounter a problem, please turn the power off, then on again. If
the unit is still not functioning normally, please review the items in the
following checklist. This guide will help you isolate the problem if the
unit is at fault. Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.
No function or display.
Vehicles ignition is off.
If connected following instructions, the unit will not operate with
the vehicle’s ignition off.
Improper power lead (Red) and battery lead (Yellow) connections.
Check power lead and battery lead connections.
•Blown fuse.
Check the fuse of the unit; replace with the proper value if
necessary.
Internal micro-computer malfunctioned due to interference noise
etc.
Press the RESET switch with a ballpoint pen or other pointed
article.
Unable to receive stations.
No antenna or open connection in cable.
Make sure the antenna is properly connected;
replace the antenna or cable if necessary.
Unable to tune stations in the seek mode.
You are in a weak signal area.
Make sure the tuner is in the DX mode.
If the area you are in is a primary signal area, the antenna may not be
grounded and connected properly.
Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast is noisy.
The antenna is not the proper length.
Extend the antenna fully; replace it if it is broken.
The antenna is poorly grounded.
Make sure the antenna is grounded properly at its mounting
location.
CD Player not functioning.
Out of operating temperature range +50°C (+120°F) for CD.
Allow the vehicles interior (or trunk) temperature to cool.
CD playback sound is wavering.
Moisture condensation in the CD Module.
Allow enough time for the condensation to evaporate (about
1 hour).
CD insertion not possible.
A CD is already in the CD player.
Eject the CD and remove it.
The CD is being improperly inserted.
Make sure the CD is being inserted following instructions in the
CD Player Operation section.
Unable to fast forward or backward the CD.
The CD has been damaged.
Eject the CD and discard it; using a damaged CD in your unit can
cause damage to the mechanism.
CD playback sound skips due to vibration.
Improper mounting of the unit.
Securely re-mount the unit.
•The disc is very dirty.
–Clean the disc.
The disc has scratches.
Change the disc.
The pick-up lens is dirty.
Do not use a commercially available lens cleaner disc. Consult
your nearest Alpine dealer.
CD playback sound skips without vibration.
The disc is dirty or scratched.
Clean the disc; damaged disc should be replaced.
Error displays (built-in CD player only).
Mechanical error
–Press . After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the problem,
consult your nearest Alpine dealer.
CD-R/CD-RW playback not possible.
Close session (finalisation) has not been performed.
Perform finalisation and attempt playback again.
MP3, WMA or AAC is not played back.
Writing error occurred. The MP3/WMA/AAC format is not
compatible.
Make sure the MP3/WMA/AAC has been written in a supported
format. Refer to “About MP3/WMA/AAC” on page 15, then
rewrite in the format supported by this device.
The sound is not output from the speakers.
Unit has no output signal of the internal amplifier.
POWER IC is switched to “ON”, refer to “Connecting to an
External Amplifier (POWER IC)” on page 19.
iPod does not play and no sound is output.
The iPod has not been recognised.
Reset this unit and the iPod. Refer to “Initial System Start-Up” on
page 10. To reset the iPod, refer to the Owner’s Manual of the iPod.
No CD is inserted.
Insert a CD.
Although a disc is inserted, “NO DISC” is displayed and the unit does
not start to play or eject the disc.
Remove the disc by pressing :
If the disc cannot be ejected by pressing , press the RESET
switch (refer to “Initial System Start-Up” on page 10) and press
again. If the disc still cannot be ejected, consult your Alpine dealer.
Information
Basic
Radio
CD (CDE-193BT only)
MP3/WMA/AAC
Audio
iPod
Indication for CD Player (CDE-193BT only)
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine UTE-92BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine UTE-92BT in the language / languages: English as an attachment in your email.

The manual is 4,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alpine UTE-92BT

Alpine UTE-92BT Quick start guide - English - 124 pages

Alpine UTE-92BT User Manual - German - 55 pages

Alpine UTE-92BT Quick start guide - German, Dutch - 124 pages

Alpine UTE-92BT User Manual - Dutch - 54 pages

Alpine UTE-92BT Quick start guide - French - 124 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info