168386
16
Zoom out
Zoom in
Previous page
1/80
Next page
16
Español
Subwoofer On and Off Mise en et hors service
du subwoofer
A
ctivación y desactivación
del altavoz de subgraves
English
Français
Appuyez pendant au moins 3 secondes
sur la touche d'éjection.
A chaque pression, le subwoofer se met
en ou hors service.
Remarques:
Le mode initial est "SUBW OFF".
Réglez sur "SUBW OFF" si vous
n'utilisez pas le subwoofer.
Quand le subwoofer est activé, son
niveau de sortie peut être ajusté.
Pour de plus amples détails, reportez-
vous à la section Réglage du volume/
basses/aigus/balance gauche-droite/
balance avant-arrière à la page 18.
Si un égaliseur sans bornes de sortie
subwoofer Ai-NET est raccordé, une
pression de 3 secondes sur la touche
d'éjection active ou désactive le N.F.P.
N.P.F. ON: Sur cette position, la sortie
pré-ampli avant du TDA-
7561R n'est pas affectée par
la balance avant-arrière.
C'est la position qu'il faut
utiliser pour entraîner un
amplificateur de subwoofer.
Mantenga presionado el botón de expulsión
durante 3 segundos por lo menos.
Cada vez que lo presione, el altavoz de
subgraves cambiará entre activado y
desactivado.
Notas:
El modo inicial es "SUBW OFF"
(desactivado).
Déjelo en "SUBW OFF" a menos que esté
utilizando el altavoz de subgraves.
Cuando el altavoz de subgraves esté
activado (ON), podrá ajustar el nivel de
salida de subgraves. Para más detalles,
consulte la sección "Ajuste del volumen/los
graves/los agudos/equilibrio entre los
altavoces derecho e izquierdo/equilibrio
entre los altavoces delanteros y traseros/
difuminador" de la página 18.
Si se conecta un ecualizador que no tenga
terminales de salida de graves controlados
por Ai-NET, cuando se mantenga presionado
el botón de expulsión durante más de 3
segundos N.F.P. se activará o desactivará.
N.F.P. ON: En esta posición, la salida
delantera de preamplificación
del TDA-7561R no se verá
afectada por el difuminador.
Esto será ideal para excitar un
amplificador de subgraves.
Press and hold the Eject button for at
least 3 seconds.
With each press, subwoofer is toggled On
or Off.
Notes:
Initial mode is "SUBW OFF."
Set to "SUBW OFF" unless the
subwoofer is used.
When the subwoofer is turned on, the
subwoofer output level can be adjusted.
For more details, refer to the Adjusting
Volume/Bass/Treble/Balance/Fader
section on page 18.
If an equalizer without the Ai-NET
controlled subwoofer output terminals is
connected, pressing and holding the
Eject button for more than 3 seconds
turns the N.F.P. on or off.
N.F.P. ON: In this position, the Front Pre-
Output on the TDA-7561R will
not be affected by the fader.
This is ideal for driving a
subwoofer amplifier.
1
1
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine tda 7561 r at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine tda 7561 r in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info