471339
7
Zoom out
Zoom in
Previous page
1/24
Next page
7
EspañolFrançais
English
1 Speaker Output Terminals
The MRV-1507/MRV-T757/MRV-F407 has two sets
of speaker outputs. Be sure to observe correct
speaker output connections and phasing. In the
stereo mode, connect the right speaker outputs to
the right speaker and the left to left. Connect the
positive output to the positive speaker terminal and
the negative to negative.
In the bridged mode, connect the left positive to the
positive terminal on the speaker and the right nega-
tive to the negative terminal of the speaker. Do not
use the speaker (–) terminals as a common lead
between the left and right channels. Do not connect
this lead to the vehicle’s chassis.
NOTE:
Do not connect speaker leads together or to chassis
ground.
2 RCA Input Jacks
Connect these jacks to the line out leads on your
head unit using RCA extension cables (sold sepa-
rately). Be sure to observe correct channel connec-
tions; Left to Left and Right to Right.
(Front to Front and Rear to Rear (MRV-F407 only))
NOTE (MRV-F407 only):
“CH-1” of the RCA input jacks works as a MONO
mode.
3 Buffer Pre-Out Jack
Use when connecting several amplifiers.
1 Bornes de sortie du haut-parleur
Le MRV-1507/MRV-T757/MRV-F407 a deux ensem-
bles de sorties haut-parleurs. Vérifier que les con-
nexions et la mise en phase des sorties haut-parleurs
sont correctes. En mode stéréo, connecter les sor-
ties du haut-parleur droit sur le haut-parleur droit et
les sorties de gauche sur le haut-parleur gauche.
Connecter la sortie positive sur la borne positive du
haut-parleur et la sortie négative sur la borne néga-
tive.
En mode ponté, connecter la sortie positive gauche
sur la borne positive du haut-parleur et la sortie né-
gative droite sur la borne négative du haut-parleur.
Ne pas utiliser les bornes haut-parleur (–) à la fois
pour les canaux droit et gauche. Ne pas connecter
ce câble sur le châssis du véhicule.
REMARQUE:
Jamais connecter les conducteurs de haut-parleur
ensemble ou sur la terre du châssis.
2 Prises d'entrée RCA
Connecter ces prises aux conducteurs de sortie de
ligne de l’unité principale en utilisant les câbles d’ex-
tension RCA (vendus séparément). Vérifier que les
connexions de canal sont correctes: gauche/vers la
gauche et droite/vers la droite.
(Avant vers l’avant et arrière vers l’arrière (unique-
ment MRV-F407))
REMARQUE (uniquement MRV-F407):
“CH-1” des prises d’entrée RCA fonctionne comme
un mode MONO.
3 Prise de pré-sortie de zone tampon
Utiliser lors de la connexion de divers amplificateurs.
1 Terminales de salida del altavoz
El MRV-1507/MRV-T757/MRV-F407 posee dos jue-
gos de salidas de altavoz. Asegúrese de observar
las conexiones y la fase correctas de la salida de
altavoz. En el modo estéreo, conecte la salida de al-
tavoz derecha al altavoz derecho y la izquierda al iz-
quierdo. Conecte la salida positiva al terminal posi-
tivo del altavoz y la negativa al negativo.
En el modo de puente, conecte la salida izquierda
positiva al terminal positivo del altavoz y la salida
derecha negativa al terminal negativo del altavoz. No
utilice los terminales de altavoz (–) conjuntamente
entre los canales derecho e izquierdo. No conecte
este conductor al chasis del vehículo.
NOTA:
Nunca conecte los cables de altavoz juntos o en el
punto de tierra del chasis.
2 Clavijas RCA de entrada
Conecte las mismas a los cables de salida de línea
de su unidad principal utilizando cables de exten-
sión RCA (vendidos por separado). Asegúrese de
que respeta las conexiones de canal correctas; iz-
quierda para izquierda y derecha para derecha.
(Delantera a delantera y trasera a trasera (sólo MRV-
F407))
NOTA (sólo MRV-F407):
“CH-1” de las clavijas de entrada RCA funciona como
un modo MONO.
3 Clavija de presalida de separador
Utilícela cuando conecte varios amplificadores.
2/1 CHANNEL POWER AMPLIFIER
MRV-1507
SPEAKER OUTPUT
SPEAKER OUTPUT
INPUT MODE
PARAME EQ
FILTER
PHASE
OFF
CH-1
BRIDGED
OFF HP
INPUT OUTPUT
CH-1
(L)
CH-2
(R)
CH-1
(L)
CH-2
(R)
LP
1(MONO)
ST 1+2
ON
0° 180°
+
+
CH-2
BRIDGED
+
1 2 3 1
(MRV-1507)
80A
FUSE
BATTERY
BATTERY
DIRECT
REMOTE GND
POWER SUPPLY
80
5
6
7
8
9
(MRV-1507)
MRV-1507/MRV-T757
BRIDGED
CH-4
CH-2
CH-3
CH-1
SPEAKER OUTPUT
(R) (L)
40A
FUSE
BATTERY
BATTERY
DIRECT
REMOTE GND
POWER SUPPLY
40
1
5
7
8
9
6
MRV-F407
4/3/2 CHANNEL POWER AMPLIFIER
MRV-F407
x1
CHANNEL-3/4
CHANNEL-1/2
OFF 1/2 3/4 1+3/2+4ON OFF ON x1 x20
LPHPHP LP INPUT CHANNEL
OFF ON
DIRECT
MODE
OFF ONx20OFF ON
CH-1MONO CH-3
CH-2 CH-4
CH-1+3
CH-2+4
(R)
(L)
PRE
OUT
INPUT
2 4
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine MRV-T757 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine MRV-T757 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info