536994
22
Zoom out
Zoom in
Previous page
1/44
Next page
ALPINE MRV-M500/MRV-F300 68-21057Z96-B (EN/FR/ES) 22
English Français Español
CONNECTION CHECK LIST
Please check your head unit for the conditions
listed below: (Fig. 8)
Remote Turn-On Lead
a. The head unit does not have a remote turn-on or power antenna
lead.
b. The head unit’s power antenna lead is activated only when the
radio is on (turns off in the tape or CD Mode).
c. The head unit’s power antenna lead is logic level output (+) 5V,
negative trigger (grounding type), or cannot sustain (+) 12V
when connected to other equipment in addition to the vehicle’s
power antenna.
If any of the above conditions exist, the remote turn-on lead of
your MRV-M500/MRV-F300 must be connected to a switched
power source (ignition) in the vehicle. Be sure to use a 3A fuse
as close as possible to this ignition tap. Using this connection
method, the MRV-M500/MRV-F300 will turn on and stay on as
long as the ignition switch is on.
LISTE DE VÉRIFICATION DES
CONNEXIONS
Prière de vérifier les points énumérés ci-
dessous concernant l’unité principale: (Fig. 8)
Conducteur de mise sous tension télé-commandée
a. L’unité principale n’a pas de conducteur de mise sous tension
télécommandée ou d’antenne électrique.
b. Le conducteur d’antenne électrique de l’unité principale est
seulement activé lorsque la radio est allumée (désactivé en mode
cassette ou CD).
c. Le conducteur d’antenne électrique de l’unité principale est
une sortie de niveau logique (+) 5V, déclencheur négatif (de
type mise à la terre) ou ne peut pas supporter (+) 12V lors de la
connexion à un autre équipement en plus de l’antenne électrique
du véhicule.
Si un des points ci-dessus se présente, le conducteur de mise
sous tension télécommandée du MRV-M500/MRV-F300 doit être
connecté à une source d’alimentation commutée (allumage)
du véhicule. S’assurer d’utiliser un fusible de 3A le plus près que
possible de la prise d’allumage. En utilisant cette méthode de
connexion, le MRV-M500/MRV-F300 est mis sous tension et
restera allumé aussi longtemps que le commutateur d’allumage
restera activé.
LISTA DE COMPROBACIÓN DE
CONEXIONES
Por favor compruebe el estado de su unidad
principal según las condiciones listadas a
continuación: (Fig. 8)
Cable para encendido remoto
a. La unidad principal no tiene un cable de encendido remoto o de
antena eléctrica.
b. El cable de antena eléctrica de la unidad principal solamente está
activado cuando la radio está encendida (desactivado en el modo
de cinta o de CD).
c. El cable de antena eléctrica de la unidad principal es una salida
de nivel lógico (+) de 5V, disparador negativo (tipo de tierra), o
no puede soportar (+) 12V cuando es conectado a otro equipo
además de la antena eléctrica del vehículo.
Si se observa una de las condiciones anteriores, el cable de
encendido remoto de su MRV-M500/MRV-F300 se deberá
conectar a una fuente de alimentación mediante interruptor
(ignición) en el vehículo. Asegúrese de utilizar un fusible de 3A
tan cerca como sea posible de esta llave de ignición. Empleando
este método de conexión, el MRV-M500/MRV-F300 se encenderá
y permanecerá encendido mientras el interruptor de ignición
esté activado.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine MRV-M500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine MRV-M500 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 1,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info