168348
7
Zoom out
Zoom in
Previous page
1/21
Next page
FR
ES
DE
SE
IT
5-EN
Subwoofer On and Off
1 Press and hold the c (Eject) button for at least 3
seconds.
With each press, subwoofer is toggled On or Off.
NOTES
Initial mode is "SUBW OFF."
Set to "SUBW OFF" unless the subwoofer is used.
When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details,
refer to the Adjusting Volume/Bass/Treble/Balance/
Fader.
Adjusting Source Signal Levels
If the difference in volume level between the MD
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the INTLZ button for at least 3
seconds.
2 Press the Preset 1 button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and MD player
closer.
3 Press the INTLZ button for more than 3 seconds
to cancel the adjusting mode.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1 Press the MODE button repeatedly to choose the
desired mode.
Each press changes the modes as follows:
NOTES
If the
55
55
5 or
66
66
6 button is not pressed in 5 seconds after
selecting the BASS, TREBLE, BALANCE, or FADER
mode, the unit automatically sets in the VOLUME
mode.
When the subwoofer is set to ON, the level of the
subwoofer can be adjusted.
2 Press the
55
55
5
and
66
66
6
buttons until the desired
sound is obtained in each mode.
NOTE
The settings of the Bass and Treble will be individually
memorized for each source (FM, MW(LW) and MD)
until the setting is changed. Depending on the
connected devices, some functions and display
indications do not work.
Turning Loudness On/Off
Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity
to bass and treble sound.
1 Press the LOUD button to activate or deactivate
the loudness mode.
The display shows "LD" when the loudness
mode is activated.
Setting Bass Frequency
The bass control centre frequency can be set at
60, 80, 100 or 200 Hz.
1 Press and hold the B.C. (Bass Control) button
for at least 3 seconds to turn on the bass control
settings.
2 Press the DN g or f UP button to select
the desired Bass centre frequency.
Each press changes the centre frequency as
follows: 60 Hz, 80 Hz, 100 Hz and 200 Hz.
NOTE
If no buttons are pressed within 5 seconds, the bass
control settings will be turned off automatically.
3 Press the B.C. (Bass Control) button for more
than 3 seconds to turn off the bass control
settings.
NOTE
Initial mode is 80Hz.
Adjusting the Contrast
It is possible to adjust the display contrast in
case the display is difficult to view.
1 Press and hold the INTLZ button for at least 3
seconds.
2 Press the Preset 4 button to select the contrast
adjusting mode.
3 Press the DN g or f UP button to adjust
the contrast.
The contrast can be adjusted between levels of –
5 and +5.
4 Press the INTLZ button for more than 3 seconds
to activate the normal mode.
VOL BASS TREB
FAD BAL
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine mdm 7741 r at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine mdm 7741 r in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info