536983
86
Zoom out
Zoom in
Previous page
1/107
Next page
86-EN
In Case of Difficulty
Basic
No function or display.
Vehicle’s ignition is off.
- If connected according to the instructions, the unit will not
operate with the vehicle’s ignition off.
Improper power lead connections.
- Check power lead connections.
•Blown fuse.
- Check the fuse on the battery lead of the unit; replace with the
proper value if necessary.
Internal micro-computer malfunctioned due to interference
noise, etc.
- Press the RESET switch with a ballpoint pen or other pointed
article.
No sound or unnatural sound.
Incorrect setting of volume/balance/fader controls.
- Readjust the controls.
Connections are not properly or securely made.
- Check the connections and firmly connect.
Screen not displayed.
Brightness/Contrast control is set at the minimum position.
- Adjust the Brightness/Contrast control.
Temperature in the vehicle is too low.
- Increase the vehicle’s interior temperature to operation
temperature range.
Connections to the DVD are not securely made.
- Check the connections and firmly connect.
The Parking Brake Lead is not connected.
The Parking Brake is not engaged.
- Connect the Parking Brake Lead, then engage the Parking
Brake. (See page 98)
Movement of displayed picture is abnormal.
Temperature in the vehicle is too high.
- Allow the vehicle’s interior temperature to cool.
The optional remote control is inoperative.
The remote control sensor setting of “Remote Sensor Setting”
(page 42) is not set to this unit (“Front”).
- Set for “Front.
Radio
Unable to receive stations.
No antenna, or open connection in the antenna cable.
- Make sure the antenna is properly connected; replace the
antenna or cable if necessary.
Unable to tune stations in the seek mode.
You are in a weak signal area.
- Make sure the tuner is in DX mode.
If the area you are in is a primary signal area, the antenna may
not be grounded and connected properly.
- Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
- Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast is noisy.
The antenna is not the proper length.
- Extend the antenna fully; replace it if it is broken.
The antenna is poorly grounded.
-
Make sure the antenna is grounded properly at its mounting location.
The station signal is weak and noisy.
- If above solution does not work, tune in another station.
Disc
Disc playback sound is wavering.
Moisture condensation in the disc Module.
- Allow enough time for the condensation to evaporate (about 1
hour).
Disc insertion not possible.
A disc is already in this unit.
- Eject the disc and remove it.
The disc is being improperly inserted.
- Insert the disc correctly. (See page 22)
Unable to fast forward or backward the disc.
The disc has been damaged.
- Eject the disc and discard it; using a damaged disc in your unit
can cause damage to the mechanism.
Disc playback sound skips due to vibration.
Improper mounting of the unit.
- Securely re-mount the unit.
Disc is very dirty.
- Clean the disc.
Disc has scratches.
- Change the disc.
The pick-up lens is dirty.
- Do not use a commercially available lens cleaner disc. Consult
your nearest Alpine dealer.
Disc playback sound skips without vibration.
Dirty or scratched disc.
- Clean the disc; a damaged disc should be replaced.
CD-R/CD-RW/DVD-R/DVD-RW/DVD+R/DVD+RW playback
not possible.
Close session (finalisation) has not been performed.
- Perform finalisation and attempt playback again.
Error displays.
Mechanical error.
- Touch [c Disc] on the Open/Tilt screen. After the error
indication disappears, insert the disc again. If the above-
mentioned solution does not solve the problem, consult your
nearest Alpine dealer.
MP3/WMA/AAC is not played back.
Writing error occurred. The CD format is not compatible.
- Make sure the CD has been written in a supported format.
Refer to “About MP3/WMA/AAC” (pages 34 to 35), then
rewrite in the format supported by this device.
If you encounter a problem, please turn the power off, then on again.
If the unit is still not functioning normally, please review the items in
the following checklist. This guide will help you isolate the problem
if the unit is at fault. Otherwise, make sure the rest of your system is
properly connected, or then consult your authorised Alpine dealer.
86


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine INE-W928R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine INE-W928R in the language / languages: English as an attachment in your email.

The manual is 8,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alpine INE-W928R

Alpine INE-W928R Additional guide - English - 84 pages

Alpine INE-W928R Quick start guide - German - 22 pages

Alpine INE-W928R Additional guide - German - 94 pages

Alpine INE-W928R User Manual - German - 107 pages

Alpine INE-W928R Quick start guide - Dutch - 22 pages

Alpine INE-W928R Additional guide - Dutch - 92 pages

Alpine INE-W928R User Manual - Dutch - 107 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info