560046
4
Zoom out
Zoom in
Previous page
1/11
Next page
41
Operating instructions for refrigerators
Installation
Foreword
If this appliance which features magnetic door seals is to replace an older appliance hav-
ing a spring-lock (latch) on the door, ensure that the spring lock is rendered unusable
before throwing away. This will prevent children from accidentally locking themselves
inside when playing.
Positioning
The appliance should be installed well away from sources of heat such as radiators, boil-
ers, direct sunlight etc.
Best performance is obtained with ambient temperature between +18°C and +43°C (class
T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its rating plate.
For building into kitchen units follow the special “Building-in” instructions given.
Electrical connection
Before you plug the appliance into an A.C. mains supply, make sure that the voltage and
frequency shown on the rating plate correspond to your home supply. A 10% fluctuation
above or below the rated voltage is admissible. To adapt the appliance to different volt-
ages, use an autotransformer having a minimum output of 500 VA.
Important
It is essential that the appliance be earthed.
For this purpose the supply cable plug incorporates a special earth contact. If the sockets
of your domestic wiring system are not earthed, get the appliance connected to a sepa-
rate earth wire by a qualified electrician in accordance with existing safety regulations
The manufacturer declines to accept any liability should this safety rule not be
observed.
This appliance complies with E.E.C. Directive No. 87/308 of 2.6.87 in relation to radio
interference suppression.
This appliance complies with the following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifi-
cations.
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories
with lukewarm water and some neutral soap so as to remove the typical smell of a brand-
new product, then dry thoroughly. Do not use detergents which will leave an odour, or
abrasive powders on the interior, as these will damage the finish.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alno AKE8216IW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alno AKE8216IW in the language / languages: English as an attachment in your email.

The manual is 0,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alno AKE8216IW

Alno AKE8216IW User Manual - German - 12 pages

Alno AKE8216IW User Manual - Dutch - 11 pages

Alno AKE8216IW User Manual - French - 11 pages

Alno AKE8216IW User Manual - Italian - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info