541401
27
Zoom out
Zoom in
Previous page
1/134
Next page
Getting Started with the Graphical User Interface (GUI) 27
Software Release 2.7.1
C613-02021-00 REV F
Option 1: Configuring the Router before Installation
Use this procedure if:
You want to configure the router before installing it in your LAN.
You will be installing the router at a remote office or a customer site and
want to configure it first.
You want a dedicated management PC permanently connected to the
router.
1. Select a PC to browse to the router from
You can browse to the router from any PC that is running a supported
operating system with a supported browser installed. See “Browser and
PC Setup” on page 24 for more information.
You need to know the PC’s subnet.
2. Connect the PC to the router
Use a straight-through Ethernet cable to connect an Ethernet card on the
PC to any one of the switch ports (see Figure 2).
Figure 2: Connecting a PC directly to the router
You can browse to the router through any VLAN or ETH port, as long as you give that
interface an IP address (see below). The recommended LAN interface is vlan1, and these
instructions assume you will use vlan1 as the LAN interface. The switch ports all belong
to vlan1 by default.
3. Access the router’s command line interface
Access the CLI from the PC, as described in “Connecting a Terminal or PC
on page 14.
4. Enable IP
ENABLE IP
5. Assign the vlan1 interface an IP address in the same subnet as the PC
ADD IP INTERFACE=vlan1 IP=ipaddress MASK=mask
6. Save the configuration and set the router to use it on bootup
CREATE CONFIG=your-name.cfg
SET CONFIG=your-name.cfg
7. On the PC, bypass the HTTP proxy server, if necessary
See “HTTP Proxy Servers” on page 25 for more information.
PC
AR400 Series router
Switch Ports
POWER
ON
OFF
RS-232
ETHERNET
3450 WAN1 DMZ
ASYN1
ASYN0 CONSOLE
21
10BASE-T/100BASE-TX SWITCH PORTS
straight-through cable
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allied Telesis AR450S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allied Telesis AR450S in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info