541350
36
Zoom out
Zoom in
Previous page
1/40
Next page
36 XONE:92 User Guide
Installer Link Options
CAUTION : The following service instructions are for use by qualified
personnel only.
To reduce the risk of electric shock do not perform any servicing other
than that described in the operating instructions unless you are
qualified to do so.
Refer all servicing to qualified service personnel.
The XONE:92 has several internal option settings designed in. Some of these are primarily for setting up the
mixer in a fixed installation situation, and the others can be used to reconfigure the MIDI system.
To gain access to these options the top panel assembly needs to be separated from the chassis. This operation
should only be carried out by qualified service personnel.
IMPORTANT! Disconnect mains input lead before removing the top panel
Removal of the top panel requires the use of a Torx T10 screwdriver. Use a good quality tool to prevent rounding
the screw heads. First remove the 4 pipped TORX screws located on rear panel in the center of each block of
input channel RCA (Phono) connectors, and then undo the 8 M3 x 8 screws that hold the front panel to the
chassis. Lift the front edge of the top panel until the two filter PCBs are clear of the chassis, and then pull the top
panel gently forward and up until access can be gained to unplug the power cable from the power supply located
on the right hand side of the chassis. Continue to lift the front edge of the top panel up until it is possible to
unplug the two harnesses from the rear connector PCB. Lift the top panel clear of the base and place on a clear
work surface.
Reassembly is the reverse procedure, but take great care to fit the harnesses correctly and to ensure that the
ribbon cables do not get trapped between any of the PCBs and the chassis. Refit the panel screws first and
tighten evenly with the chassis held firmly on a flat work surface. Finally refit the rear connector screws.
4 off AB2810 Pipped TORX
8 off AB0074 M3 x 8
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allen-Heath Xone 92 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allen-Heath Xone 92 in the language / languages: English as an attachment in your email.

The manual is 3,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info