541351
14
Zoom out
Zoom in
Previous page
1/20
Next page
14
GL3300 U
SER
G
UIDE
AUX SENDS
GROUPs 5-8 are available on
balanced XLR outputs to drive long
cable runs. INSERTS are provided
on all 8 groups to insert signal
processing devices such as
compressor/limiters into the signal
path. Use these outputs as additional
speaker feeds or for recording. In
'MONITOR MODE', GROUPs 5-
8 become AUX 5-8 outputs to provide
a total of 8 dedicated stage monitor
sends on XLR with inserts.
MUTE switches the signal off . Muted
groups are indicated by red LEDs.
AFL lets you check the output signal
after the insert and fader control.
Each group has 4 way LED metering
providing signal presence indication
and peak warning which illuminates
approximately 5dB before clipping.
The subgrouping is always fed from
the group mix regardless of GRP/
AUX REVERSE.
All the XLR outputs operate at a
nominal high level +4dBu. Ensure
correct matching to external
equipment.
SUBGROUPING
Using subgroups lets you group similar
sounds together under control of a
single fader (mono subgroup), or
panned pair of faders (stereo
subgroup). For example, the mics on
a drum kit (kick, snare, overheads,
toms), backing vocals, stage mics,
orchestral wind section etc.
Select L-R ON to route a group to L-
R as a subgroup. Position the signal
within the stereo image using PAN.
AUX 5-8 jack outputs to
send selected signals to
external effects devices.
MODE
SWITCHES
AUX 1-4 balanced outputs
feed foldback monitors with
graphic EQ on INSERT to
tune out acoustic resonances
or to minimise feedback.
AFL lets you check the
output signal after the insert
and master level control.
MONITORS
GROUPS
EFFECTS
Decide your required
console configuration
and set these recessed
switches using a pen tip
or similar.
Press REVERSE to
swap the group fader
section with the aux
master section. This
represents 'MONITOR
MODE' where the aux
mix is on the fader with
METER, AFL, MUTE,
balanced XLR output and
INSERT for full control of
the monitor mix. AFL
lets you listen to and
check the effect of the
inserted graphic EQ or
similar processing
device.
In this mode the group
mix is available on the
aux master controls to
feed the jack outputs, as
well as the subgroup
section.
Mix and match this fader
section as you require.
For example you could
have 2 as monitor sends,
4 as subgroups, and 2 as
additional outputs.
These PAN settings show subgroup 1-2 as a stereo pair, and
subgroup 3-4 panned off centre to slightly close the stereo image,
useful when the speaker stacks are widely spaced and the front
rows of the audience may be confused by a full stereo image.
{
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allen-Heath GL 3300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allen-Heath GL 3300 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info