708530
67
Zoom out
Zoom in
Previous page
1/72
Next page
67
5. MAX-MIN ALERT
5.1 Introduction:
You may set an alert for the following measurements when a maximum or minimum value is being exceeded:
Indoor temperature min/max alert
Indoor humidity min/max alert
Outdoor temperature min/max alert
Outdoor humidity min/max alert
Rainfall max alert ()
Wind speed max alert
5.2 Hi-Lo limits setup:
1. Press the button once or repeatedly until the desired display starts ashing followed by ‘HI AL or ‘LO
AL (whatever applies)
2. Use / to set the limit value
3. Briey press the button to save the value
4. Press the button again to go to the next value or wait several seconds until the settings are closed
automatically
5.3 Hi-Lo alert function setup:
1. Press the button once or repeatedly until the desired display starts ashing followed by ‘HI AL or ‘LO
AL (whatever applies)
2. Briey press the button to switch this alert on or o.
5.4 Operation:
As soon as the set limit is exceeded, an alert will sound for up to 2 minutes while the concerned value starts
ashing. You may stop the alert sound by briey pressing the ALARM/ SNOOZE button. The concerned
measurement value automatically stops ashing when it returns to within the set limit (or as soon as you
adjust the limit or switch o the alert function for this measurement).
6. ALARM CLOCK
6.1 Introduction:
You may program an alarm (wake-up) time in the WS-4900.
You may then also enable a frost alert: when the outdoor temperature falls below -3°C, the wake-up signal
will sound 30 minutes before the set wake-up time.
6.2 To set the alarm time:
1. Press and hold the button at the rear of the weather station for 2 seconds until the hour digits start
ashing
2. Use / to set the hours and then briey press , the minute digits start ashing
3. Use / to set the minutes and then briey press , the alarm time is now set
Attention: after setting the alarm time for the rst time, this function is enabled directly.
6.3 To set the alarm function:
1. Press the button once or several times to check the alarm or to switch it on/o
Only “AL” appears: the time being displayed is the set alarm time, but the alarm itself is switched
o
AL” + “ ” appears: the alarm is switched on and the wake-up signal will sound at the set alarm
time
AL” + “ ” + “ ” appears: the frost alert is set
2. Release the button, after several seconds the actual time is displayed and the alarm status, according
to the above description, remains visible
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto WS-4900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS-4900 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 15,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info