794959

Alecto WS-1560 Manual

32
Zoom out
Zoom in
Previous page
1/40
Next page
32
3. INSTALLATION
Attention: after the installation, it may take several hours up to a day before the correct values are
displayed.
Attention: the indoor unit is powered by the supplied power adaptor. As a backup, you may install
2x AA 1.5V penlight alkaline batteries. (excl.).
3.1 Power supply
Indoor unit:
The indoor unit is powered by the supplied power adaptor with model number XY06J- 0500150Q-EW.
Connect this power adaptor to the rear of the indoor unit (see 6) and insert the adaptor into a 230V wall
socket.
At the rear of the indoor unit, remove the battery cover and install 2x AA 1.5V penlight batteries according
to the markings inside the battery compartment. Replace the battery cover onto the indoor unit.
Outdoor unit:
Remove the battery cover from the outdoor unit by sliding it somewhat downwards and then taking it o󰀨.
Install 2x AA 1.5V penlight alkaline batteries according to the markings inside the battery compartment.
Replace the cover onto the outdoor unit and slide it somewhat upwards.
Batteries are not included.
Advice regarding the batteries for the outdoor unit:
Because normal alkaline batteries do not perform or do not perform well at temperatures around or below
0°C, the use of standard alkaline batteries in the outdoor unit is not recommended. For the outdoor unit,
we therefore recommend installing Lithium batteries that have been designed to function at a tempera-
ture range of -20°C to 60°C. These batteries are available through the service department of Alecto via
internet www.alecto.info
The lifespan of Lithium batteries with a capacity of 2900mAh is well over a year.
3.2 Pairing indoor unit / outdoor unit:
Automatically:
As soon as the batteries are inserted into the indoor unit, the indoor unit starts searching a signal from
the outdoor unit for 2 minutes. So, if you have installed batteries in the outdoor unit within that minute
and these units ‘nd’ each other, they will automatically connect with each other and the display of the
indoor unit will show the temperature, humidity, rainfall amount, wind speed and the wind direction as the
outdoor unit transmits this data.
Manually:
If the units can’t nd each other or you’ve replaced the batteries in the indoor unit, you may link the out-
door unit to the indoor unit as follows:
1. Make sure each outdoor unit is set to a di󰀨erent channel.
2. Press and hold the “-” button at the rear of the indoor unit for 2 seconds, the outdoor temperature and
humidity indicators now show ‘- -’. The indoor unit now waits for a signal from the outdoor unit for up to
2 minutes.
3. Within these 2 minutes, press the TX button on the outdoor unit (see the battery compartment of the
outdoor unit).
4. On the outdoor unit the red send light briey illuminates and the outdoor unit transmits a signal to the
indoor unit, automatically pairing both units with each other.
In case the paring between the outdoor unit and indoor unit doesn’t succeed, it might be caused by
the distance between the indoor unit and outdoor unit being to long. In this case, decrease the
distance and try pairing again. Also interference from other cordless devices or large steel surfaces such
as walls of reinforced concrete may be the reason for a failed pairing. In this case, try a dierent location
for the outdoor or indoor unit.
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto WS-1560 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS-1560 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 15.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info