708520

Alecto WS-1550 Manual

25
Zoom out
Zoom in
Previous page
1/28
Next page
25
OTHER FUNCTIONS
To manually set the clock:
Only follow these instructions when the WS-
1550 doesn’t receive the DCF77 signal.
1. Press and hold the CLOCK (16) button
for at least 3 seconds until the year
display starts ashing.
2. Use the UP and DOWN (11 and 12) but-
tons to adjust the following settings one
after the other and conrm each setting
by briey pressing the CLOCK (16) but-
ton:
− year
− month
− day
− hours
− minutes
3. After pressing the CLOCK button for the
last time, the time and date are set.
To manually activate the DCF-77 receiver:
With the WS-1550 in standby mode, press
and hold the DOWN (12) button for 3 sec-
onds to activate the radio receiver again for
the reception of the atomic time. However,
the receiver of the WS-1550 automatically
checks whether the signal is being received.
The daily synchronization with the DCF-77
station occurs at 2am, 3am, 8am, 12pm,
2pm and 8pm.
Around 2am and 3am the reception sensitiv-
ity is the highest.
EXPANSION
You may connect up to 3 outdoor units to
the indoor unit. You can then read the tem-
perature and humidity at 3 different locations
on the indoor unit (e.g. in your greenhouse,
in animal accommodations, in different
bedrooms).
Additional outdoor units are available via the
service department of Alecto: www.alecto.nl.
To register additional outdoor units:
1. Insert 2 batteries into the new outdoor
unit according to section INSTALLA-
TION – Outdoor unit power supply.
2. Slide the channel switch at the rear of
the outdoor unit (9) to the desired posi-
tion CH 1, 2 or 3, provided the position
is not yet in use.
3. Now press and hold the CHANNEL (15)
button (indoor unit) for at least 3 sec-
onds until the display icon (29) starts
ashing.
4. For each outdoor unit, now press the TX
(7) button behind the battery cover. The
measured value with the channel num-
ber appears in the display of the indoor
unit.
5. Now press and hold the CHANNEL (15)
button to conrm the input. The outdoor
unit is now registered.
ATTENTION: Don’t use the same channel
twice; the outdoor units will interfere with
each other.
BATTERY REPLACEMENT
Indoor unit:
If you remove the batteries from the indoor
unit while the adaptor is disconnected, all
memories and settings will be erased. That’s
why it’s recommended to connect the adap-
tor (or keep it connected) before removing
the batteries from the indoor unit.
Outdoor unit:
After replacing the batteries in the outdoor
unit(s), the outdoor unit must again be regis-
tered on the indoor unit.
To do this, follow the instructions in the sec-
tion ‘To register additional outdoor units’.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto WS-1550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS-1550 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info