97519
18
Zoom out
Zoom in
Previous page
1/29
Next page
18
RESISTANCE.
To measure the resistance, the tester measures the voltage over the
resistance when a known current flows through it and calculates the
resistance; therefor it is important to make measurements only with the
power switched OFF.
To reduce measuring-errors, caused by parallel resistors, it is advisable
to remove the resistor from the circuit and not to touch the metal part of
the test leads and/or resistor.
1. Connect the red test lead to the V/
input jack and the black test lead to the COM
jack.
2. Set the rotary switch to the desired
position.
3. Connect the test leads to the resistor.
4. Read the resistance value on the display.
In case the testleads are shortcut in the position 200M
, the display still indicates 1.0M
.
This value must be subtracted from the actual measured value.
DIODE.
When testing a diode, the LCD readout will show 1... (overload) when the
diode is in back-direction; when the diode is in conductive-direction,
then the meter readout will show the threshold value.
The same rules as described by "RESISTANCE" are applicable for the
diode measurements.
1. Connect the red test lead to the V/
input jack and the black test lead to the COM
jack.
2. Set the rotary switch to the position.
3. Connect the test leads to the diode.
Be aware that the meter only shows whether the diode conducts or blocks; there is no
indication concerning the quality of the diode.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto TM 36 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto TM 36 in the language / languages: Dutch, French as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info