Manual Alecto SCA04 (page 7 of 54) (English, German, Dutch, French)

794857

Zoom out

Zoom in

1/54

12 13

INSTALLATION INFORMATION:

Place the ceiling plate in a suitable location using plugs and screws on the ceiling.

Then screw the detector onto the ceiling plate. Press the center of the detector (test

button) for 10 seconds until the red LED ashes 1x and beeps. The SA300 has just

been switched on. Immediately carry out a rst test by pressing the center of the detec-

tor (test button) once. see also heading “Testing”.

USING, TESTING AND MAINTENANCE:

Using:

The smoke detector is in operation after the SA300 is activated.

Immediately after activating the smoke detector, the red LED gives 1x ash and 1x

beep. The red LED will now light up briey about every 60 seconds. Once smoke is

detected, the alarm will sound. Once the smoke disappears, the smoke alarm will stop

automatically.

Test:

The entire front of the detector forms the test button, press the front center to test the

SA300.

Press and hold the test button for 1 second. Within 7 seconds, the SA300 gives 2x

a series of 3 beeps and a red LED under the housing lights up 3x. Then the alarm is

still working correctly. Preferably check the detector every week. In alarm status, the

smoke detector generates at least 85dB(A) sound pressure. Do not test the smoke

detector with candles, open re, cigarettes or similar but use the test button.

Time-out function:

This function will deactivate the alarm for about 10 minutes. This function can be

enabled by pushing the HUSH/TEST button very shortly. The LED will now blink once

every 8 seconds to indicate the deactivated smoke alarm.

After 10 minutes, the alarm will be fully active once again. If there is (still) any smoke in

the environment, the alarm will go o󰀨 again.

This function can be used repeatedly.

ATTENTION:

• If the cause of an alarm is unclear, assume it’s caused by re. Immediately

evacuate the building.

• Keep the smoke detectors out of range of children.

• Protect against dust during rennovations. Without protection the smoke

detectors will lose their functionality.

Maintenance:

The smoke detector is maintenance-free. In very dusty rooms they may be cleaned by

vacuum.

PLAN AN ESCAPE ROUTE:

• Make a map and mark all locations of doors and windows and a possible escape

route. Note that you may need an escape ladder on high oors.

• Ensure everyone in the house knows the sound the smoke alarms produce and

regularly practice use of the escape route.

• Leave the house immediately according to the plan when hearing the alarm. Every

second counts: so respond quickly. If you do not notice smoke or heat, check if

everyone in the house is in a secure location.

• Do not open any doors without feeling wether the door is warm or if there is smoke

coming from underneath the doors. If it is, do not open that door. If the door is cold,

put your shoulder rmly against the door and open it a small amount to check for

any heat or smoke rst.

• If there is much smoke, keep low and take shallow breaths, preferably through a

moist towel. Call the re department as soon as you are safe outside.

REPLACING THE BATTERIES:

The detector is supplied using a built-in lithium battery. Under normal conditions the

battery will last at least ten years. If the detector is about to need replacement, the

smoke detector will make a beep sound every 60 seconds for at least 30 days. If the

smoke detector does not function, please contact your supplier.

ENVIRONMENT:

Do not throw away used batteries, but recycle them using your local chemical

depot. Product may not be thrown out as normal waste, but must be recycled

as electrical waste.

DECLARATION OF PERFORMANCE:

Is available at the following internet address:

http://DOC.hesdo.com/SA300_DOP_1.pdf

 



 



TEST-TASTE

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alecto SCA04 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3.14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alecto SCA04 Manual

Product: