707187

Alecto SCA-10 Manual

35
Zoom out
Zoom in
Previous page
1/40
Next page
35
INSTALLATION:
1. Install the mounting plate on a suitable spot
2. Use the included plugs and screws.
3. Now install the detector onto the mounting place.
4. The LED will briefly illuminate, the detector will emit a short audiosignal.
5. You can perform the first test by briefly pressing the test button, see also paragraph
“Testing”.
6. The detector is now functional.
USE:
1. Every 40 seconds , the green “POWER” LED will flash to indicate the detector is working.
2. The table below shows when the detector will sound the alarm.
CO concentration
NO ALARM
for
ALARM
for
33PPM 120 min. -
55PPM 60 min. 90 min.
110PPM 10 min. 40 min.
330PPM - 3 min.
In accordance to the EN50291-1:2010 + A1:2012 standard.
3. When the alarm sounds, it will turn off within 40 seconds after moving the detector to a space
with a CO concentration below 40PPM and without smoke.
4. The alarm sound can temporarily be turned off by pressing the TEST/SILENCE button (only
during smoke detection).
5. Every 40 seconds, the detector will automatically perform an error check.
TEST/SILENCING:
When the detector is working under normal conditions, the sensor and siren should be tested at
least every week. Press the “TEST/SILENCE” button. The device will shortly beep once, then beep
three times while the red LED blinks, then beep four times shortly while the red LED blinks. This
indicates the device is OK.
RESET ALARM:
The alarm can sometimes activate because of environmental influences, for example due to water
vapor or dust. You can press the “TEST/SILENCE” button to silence the alarm for 10 minutes.
It is not possible to stop the alarm if CO is detected.
The red LED continues flashing but the siren will stop for 10 minutes.
If there is still smoke detected after thos 10 minutes, the alarm will continue.
USER MANUAL
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto SCA-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto SCA-10 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info